If I understood you correctly, you run ipconfig on your computer to see IP address of your default gateway then trying to connect to it with Teraterm? If yes, then just IP address of DG in teraterm SSH and connect. If cannot connect try to ping it. If it is pingable then first try to connect through Telnet perhaps SSH not enabled at all on router. Or there could be an ACL that maight be blocking.

Using /nossh is strongly recommended. Without this parameter Tera Term will start connecting with the same method (telnet or SSH) that was used during last time when teraterm.ini file was saved. In case it was SSH than your macro will try to connect via SSH and will eventually fail.




Teraterm Ssh