Smart Pump Controller will automatically START the-water-pump as soon as the water level falls below the predetermined level and it will SWITCH OFF the-water-pump as soon as the tank is full. Smart Pump controller ensures no overflows or dry running of the pump thereby saves electricity and water. This device will show overhead_water_level, reservoir_water_level and Pump_status on its LCD display.

Some extra feature makes this controller SMART. Test_mode and regular_mode.

**During Test_mode the device continuously checks the water level after 30 seconds. So it decreases installation time.

**In Regular_mode the device continuously checks the water level after 3 minutes. So it Increases the lifetime of water sensors.

**During failure or the disconnect of overhead water sensor the device stops the pump after reach to avg_run : min (max run time)

**The device also shows the real-time signal from the tank, Total ON/OFF of PUMP, Last Running Time, Total Running time.

1. Applicable for home/ office/ industry and more.

2. Single-phase 220v AC. 2200watt max load.

3. Size: 17cm X 12cm X 4cm, 300 grams.

4. Internal voltage: 5vDC, 12vDC and 220vAC

5. Water sensor Voltage: 5v.

6. ON/OFF switch for manual control.

7. Smart LCD display.

8. Five-step water level display On LCD.

9. Internal 30A Relay, N/O, N/C.

10. Control by atmega8 Micro-controller.

11. Load capacity 3 HP maximum.