One approach to mixing between clipper and shear perform is by using the clipper-over-comb method. Because of this method, work with a removable knife clipper with a sizable knife (#1 1/2 or higher). The more expensive knife gives the client a simpler combination as the hair will be cut a uniform period with a feathered end. Never make use of a small edge or trimmer to mixture because the knives will give the hair a very dull cut and keep lots of small lines of demarcation.
Yet another way of blending is blending-shears-over-comb. Raise the hair up with the brush and use the mixing shears to cut the last 1/4" of the hair. When training the tagliocapelliuomo , it is important to slightly overdirect before cutting as this will create a softer blend. Make sure to only reduce the past 1/4 '" to 1/8" of hair. Never thin hair near to the scalp as this can produce a fuzzy search by causing very small locks to stand out through the lengthier hairs. Use a loss shear with at least 40 teeth. Shears with larger teeth can create lines. Prevent applying typical shears to mixture because the knives can give the hair a really dull reduce and leave plenty of little lines of demarcation.
You may also create a blend utilizing a standard right blade (without a brush attachment). The hair is raked with the blade at a 45 degree angle. The angle of the knife is quite important. If the blade is held in an even more flattened place, a lot of hair is going to be removed. If the blade is presented more upright, it'll damage the cuticle. This strategy was made common by the Roffler colleges and shouldn't be attempted and soon you have acquired hands-on education by a barber/stylist who is competent in the technique. For razor blending, it is essential that the hair be very wet.
A razor (with guard) or shear-point practices can be utilized to offer the haircut texture by chopping the ends of the hair in clear, various lengths. Consistency is desirable in haircuts which can be worn spiked or disheveled. The blade (with guard) is employed to reel the stops of the hair between the knife and the thumb to create the different lengths. When pulling the hair between the razor and flash, contain the razor at an angle and use a gathering motion. The shear-point process is used to slice the stops of the hair at an position (or even snipping out alternating pieces) to include texture. Perform these techniques just following hands-on instruction from the competent instructor.