stone774

Current Things: +2

@Stone3Ddesign 

Current Models (Sets): +3

Stone774 

Current Objects: +3

@Stone

Current Models: +3

Idea

This project was built with the intent of a challenge to make something large yet useful, while this Lathe cannot hold anything large like a standard store bought one could it allow for tinkering and small projects.

Parts

Motor- Vevitts Small Brushed Permanent Magnet Electric Motor 24V 350W  

Power Supply- QNNP® LED Driver 60 Watts 12V DC with Plug 

Dial- RioRand 6V-90V 15A PWM DC Brushed Motor Speed Controller 

Pully/Gear-2PCS Set GT2 Synchronous Aluminum Timing Pulleys (20-60T-8B-6) 

Idea

The Goal of this project was to build a light that could quickly be used to check a print late at night without having to grab a flashlight or turn on the large overhead light. The two bolts on either side of the print must be temporarily removed to slide it on, mount provides a decent friction to keep it in place.

Parts

9V Battery Connector- California JOS 3 PCS 9V Battery Connector  

 Led light Strip- RV Flexible LED Strip Light 12V Dimmable Tape Light 

Button/Switch-100PCS 8.5X8.5MM 6Pin Push Tactile Power Micro Switch 

*Note that the 9V Battery Connector and Led light Strip listed are different from what is use as scrap parts & parts that are no longer being sold were used.