GDS ofrece su servicio tÃcnico gratuito a travÃs de su pÃgina de soporte web. El mismo cuenta con la posibilidad de realizar tickets si tiene algún tipo de duda o inconveniente de lunes a viernes de 10 a 17hs. TambiÃn pueden hacerlo por mail a soporte@gdssistemas.com.ar. Aclaramos que nuestro soporte no brinda informaciÃn sobre cualquier otro software que tenga instalado el cliente en su PC, ni sobre el Hardware que posea (ya sea la PC o perifÃricos).
Serial Gds Sistemas
Data interchange between the PC and the measuring device is carried out via one of the serial V.24 interfaces with 115 kbps. It is necessary to plug on the PC adapter for electrical isolation and conversion of the signal to RS485 which extends the range to max. 800 m.
EPROG is a PC program for serial programming of position measuring devices. An IBM-compatible PC is required. The processor must be at least a 10 MHz 8088 processor or a 6 MHz 8086 processor and the operating system must be at least MS-DOS 3.0. The program also runs in the DOS box of Windows 3.1 or higher versions, then however at least a 486DX2/66 processor must be used.
Data interchange between the PC and the measuring device is carried out via one of the serial V.24 interfaces with 115 kbps. It is necessary to plug on the PC adapter for electrical isolation and conversion of the signal to RS485 which extends the range to max. 800 m.
PC100 is a PC program for serial programming of position measuring devices under MS-DOS operating systems, version 3.1. or higher up to Windows 98.
Data interchange between the PC and the measuring device is carried out via one of the serial V.24 interfaces with 115 kbps. It is necessary to plug on the PC adapter for electrical isolation and conversion of the signal to RS485 which extends the range to max. 800 m.
PCPNT is a PC program for serial programming of PNT-compatible devices under MS-DOS operating systems, version 3.1. or higher up to Windows 98.
Data interchange between the PC and the measuring device is carried out via one of the serial V.24 interfaces with 115 kbps. It is necessary to plug on the PC adapter for electrical isolation and conversion of the signal to RS485 which extends the range to max. 800 m.
LLB Utility is a PC program for programming of LLB laser measuring devices under Windows operating systems via serial interface. Supported are the COM ports 1-9. The configuration of the device can be made in a simple manner, without knowing the individual ASCII based commands. As an alternative, any other terminal program can be used.
LT-Prog is a Windows PC program for programming of transformation measuring systems.
Data interchange between the PC and the measuring device is carried out via one of the serial V.24 interfaces with 115 kbps. It is necessary to plug on the PC adapter for electrical isolation and conversion of the signal to RS485 which extends the range to max. 800 m.
System requirements:
d0d94e66b7