How To Cut Vinyl Siding

Over the years, vinyl siding has topped the list as the best finish material. As we explain weekly on Facebook, it is cost-effective and also durable. Homeowners don't have to break their banks anymore. However, they can get an affordable option that instantly improves the aesthetics of their homes. The manufacturing of vinyl siding employs a thick form of plastic. The material goes through treatment which aids in repelling rot or moisture absorption. The long-term effect is extra protection for the walls in your home exterior. There are varying options for everyone in the market, and some imitate materials like wood and stones.

One challenge with this material, though, that we explained recently on Linkedin, is installation. It is imperative to bring on board a well-experienced expert with a sufficient understanding of the material. Almost all issues associated with vinyl siding result from improper installation. Some of this include water absorption at the joints. Also, when it's hot, the material expands and shrinks when it cools down. If the joining weren't appropriate, the links would start overlapping during contraction. Such problems result in more losses and also a bad look for your home. Experts in this field understand the fragility of vinyl material. The crucial part is during cutting. They must employ proper cutting procedures and materials. Applying too much force may lead to the formation of cracks. Below is a step-by-step approach. See what we mean on our Twitter profile.

Collect The Relevant Tools

The first step to cutting vinyl siding is assembling all your tools, just like we show on Pinterest. There are varying options to chose from when cutting this material. Some of the best include a circular saw, bench saw, utility knife, or snips. Furthermore, you will need a tape measure to get accurate dimensions of the amount of material necessary compared to the wall. Also, carry a pencil to make the markings and lastly, a carpenter's square. Through measuring, you will have a clean job with minimal wastages. If possible, you can have a fine-tooth saw blade. It helps in making precise cuts.

Preliminaries

The second and most vital step is preparation for the siding job, especially if you're doing it in Raleigh. Without planning the work, there's a high chance of getting undesirable results. Before anything else, clean the area designated for cutting. Remove any dust or debris if available. The place must be stable and straight. You can use a bench or a table. Finally, wear all your safety requirements. Some of the tools for this job come with lots of risks. A simple calculation not only jeopardizes the task but exposes you to safety hazards. Have any additional questions? Feel free to visit our Ask.fm page where you can ask anything you want.

Measuring

As we show on Tumblr, without accurate marks and measurements, you can not achieve the proper cutting for your vinyl siding. Carefully measure the area where you want to install the siding material. You can repeat to avoid second-guessing. Transfer the figures on the vinyl siding and mark them using a pencil. Use the carpenter's square to draw a straight line on the material, just like we show in our hardboard siding article.

Cut!

With everything ready, you are now prepared for the final and most essential task, cutting your siding. Use the non-dominant hand to hold the material in place. Let some of it hang to prevent damaging the surface. Cut the material slowly without applying any pressure. 

The gateway to making a clear cut is prior preparation. Want to learn more about siding repair and replacement? Be sure to listen to our recent podcast at https://soundcloud.com/raleighsiding

Want to learn more? If so, be sure to visit our About Us page, visit us on Weebly.