Perfect Way to Make Leather Wallet with step by step Tutorial

I will share with you how to make an Leather Wallet wallet. The details are as follows:

2. According Personalized Wallet to the pattern, make the inner and outer leather materials (here the outer leather is Togo cowhide, and the bottom leather is French sheep);

3. Cut the core material according to the pattern,

4. Paste the core material well, and round the edges with large-size chamfering, the effect will be better when the drum is raised;

Cutting and bonding

1) After selecting the leather material, the first step is to perform the initial cutting and ensure that the two pieces of each strap are taken from the same leather material.

2) Put the mold on the whole leather, press it with a big press machine, the leather will be cut out.

3) Layer cutting. To make a soft and comfortable watchband, the overall thickness is also important. This requires peeling the leather. Push the first cut leather into the cutting machine, and it will be evenly cut into two thin layers. , The surface layer is retained, and the thickness is controlled at about 0.7mm, and other leather materials used as linings also need to undergo the same process.

4) The two layers of leather are not directly bonded, and the reverse side of the cut outer layer of leather needs to be glued with a layer of material for lining.

5) Before bonding, the edges of the two layers of leather need to be peeled further, so that the outer layer of leather needs to be folded back and bonded with the inner lining, so the overlapping part of the two layers of leather must be thinned. When the two parts are bonded together, it can ensure that its overall thickness is uniform and consistent with the other parts. So far, the pre-Cutting stage has also been completed.

6) Cut and shape again. Use the mold for making wallets to cut out the required leather materials from the previously bonded wallet master. In this way, the prototype of the wallet came out, but the production of the wallet has just begun.

5. Use a scribe to draw a side line on the back edge of the bottom leather;

6. Lay the core material along the sideline, then paste it with the outer skin, shape the edge with a deer bone stick, and then chop it;

7. A pit was formed at the root of a small sanding rod;

8. Punch the hole and install the snap button into it;

9. Laminate in the same way, but pay attention to curved surfaces;

10. Stitching and assembly;

Suture:

Beat the suture with an awl, the suture that has been beaten will be firmer and smoother than the untreated right suture.

Among them, first sanding with coarse sandpaper, and then coloring (the color is the same as the strap), so that the dye soaks to the edges of the two layers of leather, so that the colors of the upper and lower layers are the same.

Next, use a hot soldering iron to press out an obvious groove on the outside of the strap stitches (both sides must be pressed) to make the two layers of leather bond more tightly, and press out the excess glue, so that even the wallet The edges will not crack after a long time. Then use fine sandpaper to grind the edges again, apply the dye again, and dry.

Grind and wax again.

After drying the purse, use a soldering iron to heat and fix the dyed part, then wax it, and polish it again with fine sandpaper. Then, after waxing a side and wiping it with a dry cloth, this wallet is basically finished.