Myket Panel

Lastly, the company can leverage its technology and know-how to solve similar problems in the big new markets including the industry of fresh markets and flea markets. A significant amount of capital in the fresh markets and flea markets has always been overlooked because it is quite challenging to solve the problems as it requires enormous resources which is not worth tackling and investing in for typical entrepreneurs in the early stages. However, Horganice has generated ideas, conducted research, and uncovered extensive customer insights. It concludes that there is a similar nature to the problem among the group of market owners and panel tenants, similar to that of dormitory owners and tenants. By leveraging the existing technology and infrastructure, Horganice has developed Myket Pro to serve this market. Additionally, Horganice obtains the opportunity to work with TalaadThai, the largest agricultural wholesale market in ASEAN. After more than two years of collaboration, TalaadThai has transformed itself and revolutionize the wholesale industry by having Horganice as an enabler. Eventually, TalaadThai changed the status from the system user to be a co-investor. This demonstrates a solid problem-solving ability and the effectiveness of Horganice's management system.

As with analog amplifiers, most digital amplifiers will provide an attenuation control, allowing you to reduce the signal level being fed into the amplifier - either via a front panel interface or software interface. This is a line level control, located post-input, before the amplifier stage. The attenuation controls will have a range of minus infinity to 0dB.

Myket Panel

Download 🔥 https://geags.com/2y2NA3 🔥

Output level adjustments on the EXPO (8-channel, single full rack space) are made via analog attenuation pots on the front panel of the device. A small flathead screwdriver is the tool required. Fully clockwise will give +24dBu output, rotating the screw fully counterclockwise will reduce the output voltage to -31dBu (mic level). It is a variable output, there are no detente positions between the two limits. To calibrate the analog output of the EXPO to the input of the next device send a 1kHz sine tone at 0dB RMS over CobraNet to the EXPO. Set the next device to its lowest input sensitivity, normally 0dB or line level on the input (and ensure phantom power is disabled), then connect the EXPO output to the input of the next device. Observe the input meter of the device: if the meter is above 0dB use the attenuation pot on the EXPO to reduce the signal to 0dB on the input meter of the new device; if the meter is below 0dB increase the input sensitivity of the new device to raise the input signal to 0dB. ff782bc1db