How We Research
We compare products from their published specs and features; the verdicts below are our independent editorial opinions.
Updated: 2026-09-28 · 7 min read · Independent comparison
• MOSWAG 3.5mm — biggest strength: a passive, dual-shielded 3.5mm-to-2RCA Y cable with gold-plated connectors and a braided nylon jacket that's rated to survive 10,000+ bend tests.
• MOSWAG 3.5mm — biggest trade-off: it does no conversion at all. It only works if the source already outputs analog audio through a 3.5mm jack and the destination takes RCA.
• NCGGY 192KHz — biggest strength: it actively converts a toslink optical digital signal into analog 3.5mm audio at up to 192KHz, so it can feed headphones or powered speakers from a digital-only source.
• NCGGY 192KHz — biggest trade-off: it's unidirectional (optical in, 3.5mm out only), it needs USB power to run, it won't pass 5.1 Dolby/AC3, and volume must be adjusted on the output device, not the TV remote.
• Who each is for: MOSWAG for anyone connecting a phone, tablet, MP3 player or laptop to an amplifier or receiver; NCGGY for anyone whose TV, DVD/Blu-ray player, set-top box or PS3/PS4 has no analog headphone out.
The MOSWAG 3.5mm cable is a straightforward piece of analog plumbing. One end is a 3.5mm male plug; the other splits into two male RCA plugs, one for each stereo channel. There is no chip, no power requirement and nothing to configure — you plug the 3.5mm end into a headphone jack and the RCA ends into a receiver, amplifier, speaker or car input.
What it does best is solve a very common mismatch: modern portable devices kept the 3.5mm jack while home audio gear kept RCA. MOSWAG lists compatibility with iPhone, iPod, iPad, MP3 players, CD players, laptops, tablets and any other device with a 3.5mm audio jack on one side, and amplifiers or receivers with RCA jacks on the other. That's the whole job, and it does it without a driver or a power brick.
The build is where this cable earns its keep. The core is oxygen copper with dual shielding, which the spec sheet says reduces susceptibility to outside interference. The connectors are gold-plated and sit inside aluminum alloy casings that resist corrosion, and the extended wire joint is designed specifically so the RCA ends don't fold over when the cable bends behind a shelf. The outer jacket is braided nylon in white, and MOSWAG states it passes 10,000+ bend tests — the kind of figure that matters if this cable lives in a bag or gets yanked around behind a desk. It's also listed as heat resistant and shaped as a round cable, and it ships as a single unit in a sealed anti-static bag.
Who should buy it: anyone connecting a phone, tablet, laptop or MP3 player to an amp, receiver, TV or car stereo that takes RCA. It's the right call for a permanent desk setup, a car aux-in conversion, or a quick fix when the only free input on your amplifier is RCA.
NCGGY 192KHz: Who It's For
The NCGGY 192KHz is a different category of product entirely. It's a digital-to-analog converter built into a short cable assembly: a toslink optical input on one side, a 3.5mm analog output on the other. It takes digital PCM audio and turns it into something headphones or powered speakers can actually play.
The key spec is that 192KHz figure — it's the DAC's supported sample rate, and it's the reason this converter is worth considering over a basic fixed-rate adapter. NCGGY is described as a manufacturer that develops its own audio cables and adapters, including XLR, guitar and stereo jack cables, so this converter comes from a company that does audio cabling as its core business rather than as a side line.
There are three things you genuinely need to know before buying. First, it is unidirectional: optical in, 3.5mm out. It will not take a 3.5mm signal and convert it to optical. Second, it requires power. The included USB cord has to go to a 5V/1A port — your TV's USB socket or a wall charger — or the converter won't run reliably. Third, volume is controlled at the output device, not by your TV remote, so you'll be adjusting levels on your headphones or speakers.
Compatibility is decent for a converter at this level: HDTVs, set-top boxes, DVD and Blu-ray players, PS3 and PS4. The package includes the optical-to-3.5mm adapter plus a 3ft (1m) 3.5mm audio cable, so you can go straight to headphones. NCGGY specifically frames the 3.5mm output as an advantage over converters that only offer RCA, because it means direct, personal headphone listening without disturbing anyone else in the room. One limitation worth flagging: it does not support 5.1-channel signals like Dolby AC3, so you must switch your source's audio output to PCM first.
Who should buy it: someone with a digital-only source — a TV, console or disc player — who wants private headphone listening or a feed to powered speakers. Who should skip it: anyone who just needs to connect a phone to an amp (the MOSWAG is simpler and needs no power), and anyone hoping to send audio the other direction or run a surround signal through it.
• Best for headphone-jack-to-amplifier connections → MOSWAG 3.5mm. Analog in, analog out, no power needed.
• Best for TVs, consoles and disc players with no analog output → NCGGY 192KHz. It's the only one of the two that converts a digital signal.
• Best for private headphone listening from a TV → NCGGY 192KHz. The 3.5mm output goes straight into headphones.
• Best for durability → MOSWAG 3.5mm. Braided nylon, gold-plated connectors, aluminum alloy housings and a 10,000+ bend-test rating.
• Best for a car aux-in or desk setup → MOSWAG 3.5mm. Dual RCA into an amp or head unit is exactly its use case.
• Best for higher-resolution digital audio → NCGGY 192KHz. Its 192KHz sample-rate support is the headline spec.
• Simplest to live with → MOSWAG 3.5mm. No USB power, no PCM setting to change, no remote-control caveat.
• Most setup caveats → NCGGY 192KHz. Unidirectional, needs 5V power, and won't handle Dolby AC3/5.1.
In my opinion, the right pick comes down to one question: does your source output analog audio or digital? If you have a phone, tablet, laptop or MP3 player with a 3.5mm jack and you're feeding an amplifier, receiver or car stereo, I'd buy the MOSWAG 3.5mm. It needs no power, has no settings to change, and the braided, gold-plated build is the kind of thing that survives years of being plugged and unplugged.
If your TV, set-top box, Blu-ray player or console only gives you an optical output and you want headphone listening, the MOSWAG can't help you at all — that's when I'd buy the NCGGY 192KHz, accepting the USB power requirement and the PCM-only limitation as the cost of getting a digital signal into analog headphones.
No. The MOSWAG is a passive analog Y cable with no electronics. The NCGGY is an active DAC that converts optical digital audio to analog 3.5mm and requires USB power.
No. It's unidirectional — optical in, 3.5mm out only. For a phone-to-amplifier connection, the MOSWAG 3.5mm to 2RCA cable is the appropriate product.
Not with 5.1 signals like Dolby AC3. You need to set your source's audio output to PCM first. It also can't be controlled by your TV remote — volume is adjusted on the connected headphones or speakers.
Value depends entirely on your ports, not on the products themselves. If you have a 3.5mm output and RCA inputs, the MOSWAG is all you need. If you have an optical output and want analog headphones, only the NCGGY solves the problem. Check the current price on Amazon for whichever one matches your setup before deciding.
As an Amazon Associate I earn from qualifying purchases.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon and affiliated sites.
When you buy through links on this page, we may earn a commission from qualifying purchases at no extra cost to you.
Amazon and the Amazon logo are trademarks of Amazon or its affiliates. This site is an independent third-party review and is not affiliated with, endorsed by, or sponsored by Amazon or the product brands mentioned.
See also: JBL Tune 510BT vs Monster Persona 3rd, PLT Plantronics vs HyperX HHSS1C-KB-WT/G: Wireless Headset, Logicool G Hiarkio G333-BK vs Black Shark Gaming Earbuds, Razer BlackShark V3 vs CXK Bone Conduction Headphones