Samsung Ml 1640 V1010078 Toner Reset: A Simple Solution for Your Laser Printer

Samsung ML 1640 V1010078 Toner Reset

The Samsung ML 1640 is a monochrome laser printer that uses a toner cartridge to print documents. The toner cartridge has a chip that monitors the amount of toner left and stops the printer from printing when the toner is exhausted. However, sometimes the chip may not recognize that the toner has been refilled or replaced, and the printer may display a red light error or a toner exhausted message. In this article, we will show you how to reset the toner cartridge of the Samsung ML 1640 printer using a firmware update.

What you need

A Samsung ML 1640 printer with a starter or standard toner cartridge.

A computer with Windows operating system and a USB cable.

The firmware update file for the Samsung ML 1640 printer. You can download it from [here].

How to reset the toner cartridge

Turn off the printer and disconnect the power cord.

Connect the printer to the computer using the USB cable.

Press and hold the power button on the printer for about 15 seconds. The printer will enter download mode.

Run the firmware update file on your computer. It will detect the printer and show its current firmware version.

Click on "Update" and wait for the process to complete. Do not turn off the printer or disconnect the USB cable during this time.

When the update is done, you will see a message saying "The firmware update was completed successfully". Click on "OK" and close the program.

Turn off the printer and reconnect the power cord.

Turn on the printer and wait for it to initialize. The red light error or the toner exhausted message should be gone, and you should be able to print normally.

Troubleshooting

If you encounter any problems during or after the firmware update, you can try the following solutions:

Samsung Ml 1640 V1010078 Toner Reset

Download

If the firmware update program does not detect the printer, make sure that the printer is in download mode and that the USB cable is properly connected. You can also try using a different USB port on your computer.

If the firmware update fails or gets stuck, do not turn off the printer or disconnect the USB cable. Wait for a few minutes and try again. If it still does not work, you may need to contact Samsung support for assistance.

If the printer does not work properly after the firmware update, you can try resetting it to factory settings. To do this, press and hold the cancel button on the printer for about 20 seconds. The printer will print a test page and restore its default settings.

Conclusion

The Samsung ML 1640 V1010078 toner reset is a simple and effective way to extend the life of your toner cartridge and save money on printing costs. By updating the firmware of your printer, you can bypass the chip that limits the number of pages printed by your toner cartridge. However, you should be careful when performing this procedure, as it may void your warranty or damage your printer. If you have any doubts or questions, you can consult your user manual or contact Samsung support for more information.

0493d141df