We compare products from their published specs and features; the verdicts below are our independent editorial opinions.
Updated: 2026-10-03 · 7 min read · Independent comparison
If you want a proper audiophile-grade hybrid driver earphone with a detachable cable and a metal faceplate, choose Linsoul KZ ZSX 5BA+1DD; if you need a long-cord, no-mic workhorse for a PC or TV with silicone tips that stay put, choose WMSZMSM Headphones. That is the whole decision in one line. Everything below explains why, and which one fits the way you actually listen.
• Linsoul KZ ZSX 5BA+1DD — biggest strength: a six-driver hybrid setup (5 balanced armature + 1 dynamic) with a wide 7 Hz–40 kHz frequency response, zinc alloy faceplate and a detachable recessed 2-pin cable you can upgrade or replace.
• Linsoul KZ ZSX 5BA+1DD — biggest trade-off: it is a wired, no-mic audiophile piece with a short 125 cm cable, so it is not built for lounging across the room from a TV, and 24 ohm impedance means it wants a decent source to sound its best.
• WMSZMSM Headphones — biggest strength: a 6.5 ft extra-long cord, lightweight wire with no adapter needed, silicone tips for a secure seal, and a simple 32 ohm dynamic driver that any phone, tablet or laptop can drive.
• WMSZMSM Headphones — biggest trade-off: plastic enclosure, a plain dynamic driver, and a narrower 20 Hz–20,000 Hz range, so it prioritizes reach and convenience over detail and soundstage.
• Who each pick is for: the KZ ZSX is for the listener who cares about tuning, detail and cable flexibility; the WMSZMSM is for the person who wants earphones that just work at a desk, in a call, or in front of the TV.
The KZ ZSX is the more ambitious design of the two. Inside, it runs two DWEK balanced armature drivers for the mids and highs, a 30095 balanced armature for the top end, and a single 10 mm double-magnetic dynamic driver for the low end. That is five BA plus one DD, and the payoff is a frequency response that reaches from 7 Hz all the way to 40 kHz. In plain terms, this is a driver array built to separate instruments and keep the top end airy without smearing the bass.
Sensitivity is rated at 111 dB with 24 ohm impedance, which tells me it is efficient but still happier with a clean source than with a noisy laptop jack. The ergonomics are molded around cochlea data to sit like a custom fit, which helps with both comfort over long sessions and passive noise isolation. Wired, 3.5 mm, no mic, cyan finish, touch-based media control on the wired controller.
Buy it if you listen critically, you want a replaceable cable, and you like the idea of a hybrid tuning with a genuinely wide range. Skip it if you mainly need a long cord to reach across a room, or you want a built-in mic for calls — this model is explicitly the without-mic version.
WMSZMSM Headphones: Who It's For
The WMSZMSM Headphones are built around a different priority: reach and simplicity. The headline feature is the 6.5 ft cord, which is longer than what most earphones give you. That extra length is the entire point — you can sit back from a desktop tower, move around a small room, or watch TV without yanking the plug out of the jack. The wire is lightweight and needs no adapter cable, so there is nothing extra to lose or fumble with.
The driver is a single dynamic unit, 32 ohm impedance, 20 Hz–20,000 Hz. That is the standard full-range window, and 32 ohm is an easy load for basically any phone, tablet, laptop or TV headphone jack. You will not need a DAC or amp to get usable volume. The silicone tips are shaped for a secure, fall-resistant fit and create a seal that blocks outside noise — useful for focusing at a desk or following dialogue on a screen.
The enclosure is plastic with a metal paint process, and the stated goal is durability over extended use. The design is minimalist, white, with rounded tips. Control is remote-based media control on the wired line, and there is no microphone. It is a practical, no-fuss earphone.
Buy it if your listening happens at a computer, in front of a TV, or on conference calls where you need length and a stable fit more than you need detail. Skip it if you want a detachable cable, a metal build, or the wider frequency range a hybrid driver array can deliver.
• Best for critical listening and detail → Linsoul KZ ZSX 5BA+1DD. Six drivers and a 7 Hz–40 kHz range versus one dynamic driver at 20 Hz–20,000 Hz.
• Best for reaching across a desk or room → WMSZMSM Headphones. A 6.5 ft cord beats a 125 cm cable for TV and PC use.
• Best for long-term durability and repair → Linsoul KZ ZSX 5BA+1DD. Zinc alloy faceplate, resin cavity, detachable recessed 2-pin cable with pin protection.
• Best for plug-and-play on any device → WMSZMSM Headphones. 32 ohm impedance and no adapter needed means it works straight out of a phone, tablet, laptop or TV.
• Best for a secure, sealed fit with soft tips → WMSZMSM Headphones. Silicone tips designed for a fall-resistant fit and noise isolation.
• Best for a custom-like ergonomic fit → Linsoul KZ ZSX 5BA+1DD. The cavity is molded from cochlea data to sit like a custom earbud.
• Best for future cable upgrades → Linsoul KZ ZSX 5BA+1DD. Only one of the two has a detachable, upgradeable cable.
• Best for a minimalist, single-purpose setup → WMSZMSM Headphones. No mic, no adapter, no extras to manage.
If I were buying for myself, I would take the Linsoul KZ ZSX 5BA+1DD. In my opinion, the hybrid driver array, the 7 Hz–40 kHz range, the zinc alloy and resin build, and especially the detachable recessed 2-pin cable make it the earphone that stays useful for years instead of months. It is the one I would reach for when I actually want to hear the music.
The WMSZMSM Headphones are not a worse product — they are a different tool. If your day is spent at a PC or in front of a TV and you want a long cord and a soft, secure fit with zero setup, that is the smarter pick. For sound quality and longevity, though, my vote goes to the KZ ZSX. Check the current price on Amazon before you commit, since that is the one variable I cannot weigh for you.
In-ear earphones are headphones whose tips sit inside the ear canal rather than resting against the outer ear. Both products here are in-ear designs with rounded tips — the KZ ZSX uses a resin cavity molded from cochlea data, and the WMSZMSM uses silicone tips.
In-ear monitors are in-ear earphones built for accurate, detailed playback, often with multiple drivers per side. The KZ ZSX fits that description with five balanced armature drivers plus one dynamic driver, while the WMSZMSM uses a single dynamic driver at 32 ohm.
Wipe the tips and nozzle gently with a dry cloth or a soft brush, and remove silicone tips to clean behind them. Never push tools or liquid into the nozzle or driver housing — on the KZ ZSX that housing is resin and zinc alloy, and on the WMSZMSM it is plastic.
Insert the tip into your ear canal and twist slightly until it seals comfortably. The KZ ZSX is shaped for a custom-like fit and the WMSZMSM uses silicone tips designed to resist falling out, so both reward a proper seal for better sound and noise isolation.
As an Amazon Associate I earn from qualifying purchases.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon and affiliated sites.
When you buy through links on this page, we may earn a commission from qualifying purchases at no extra cost to you.
Amazon and the Amazon logo are trademarks of Amazon or its affiliates. This site is an independent third-party review and is not affiliated with, endorsed by, or sponsored by Amazon or the product brands mentioned.
See also: LOBKIN Bone Conduction Headphones vs LC-dolida Sleep Mask, Philips Coolplay Kids On-Ear vs JBL Junior 320, Purity Air Open Ear vs QAZITV Bone Conduction Headphones, DECIBEL DEFENSE Ear Protection vs PROHEAR 037BR04