Jotun Protects Property Jotafix Epoxy Primer Product description This is a two component amine cured epoxy mastic coating. It is a surface tolerant primer designed for application with brush and roller. Specially designed for areas where optimum surface preparation is not possible or desired. Provides protection in environments with high corrosivity. Can be used as primer, mid coat, finish coat or as single coat system in marine atmospheric environments. Suitable for properly prepared carbon steel, galvanised steel, stainless steel and a range of aged coating surfaces. It can be applied at sub zero surface temperatures. Typical use General: Primarily designed for smaller maintenance and repair jobs. Marine: Outside hulls, exterior and interior areas. Approvals and certificates Grain, Newcastle Occupational Health When used as part of an approved scheme, this material has the following certification: - Low Flame Spread in accordance with EU Directive for Marine Equipment. Approved in accordance with parts 5 and 2 of Annex 1 of IMO 2010 FTP Code, or Parts 5 and 2 of Annex 1 of IMO FTPC when in compliance with IMO 2010 FTP Code Ch. 8 Additional certificates and approvals may be available on request. Product data Property Test/Standard Description Solids by volume Gloss level (GU 60 ) Flash point Density VOC-US/Hong Kong VOC-EU VOC-China VOC-Korea ISO 3233 ISO 2813 ISO 3679 Method 1 calculated US EPA method 24 (tested) (CARB(SCM)2007, SCAQMD rule 1113, Hong Kong) IED (2010/75/EU) (theoretical) GB/T 23985-2009 (ISO 11890-1) (tested) Korea Clean Air Conservation Act (tested) The provided data is typical for factory produced products, subject to slight variation depending on colour. All data is valid for mixed paint. Gloss description: According to Jotun Performance Coatings' definition. Date of issue: 10 April 2018 Page: 1/5 This Technical Data Sheet supersedes those previously issued. The Technical Data Sheet (TDS) is recommended to be read in conjunction with the Safety Data Sheet (SDS) and the Application Guide (AG) for this product. For your nearest local Jotun office, please visit our website at www.jotun.com
Recommended as a primer on blast cleaned steel surfaces in epoxy paint systems in corrosivity classes C2-C5. Suitable also for zinc-, aluminium and stone based substrates. Can also be overcoated with polyurethane paints. The paint provides the opportunity to extended recoating times.
Jotun Paint Msds Primer Download
DOWNLOAD 🔥 https://tiurll.com/2y3LPW 🔥
Used over blast cleaned steel surfaces as a primer in epoxy paint systems in environmental classes C2-C5. Specially recommended for frameworks of industry buildings, pipe bridges, conveyors and structural constructions of process industry. Can also be overcoated with polyurethane paints. 2351a5e196
physiology in nutshell ak jain pdf download