How to Download and Install the Icom RS-BA1 IP Remote Control Software
The Icom RS-BA1 is a software that allows you to remotely control your Icom transceiver over an IP network. You can operate your ham radio from another room, home or state, with low latency and high quality audio. The RS-BA1 also provides spectrum scope and waterfall functions for compatible transceivers, such as the IC-7610 or the IC-9700.
In this article, we will show you how to download and install the RS-BA1 software on your PC. You will need a previous version of the RS-BA1 software installed before you can update to the latest version 2. You will also need a USB cable or an Ethernet cable to connect your Icom transceiver to your PC.
Icom Rs-ba1 Ip Remote Control Software Downloadl
Download: https://itluperpe.blogspot.com/?mg=2vKW8P
Step 1: Download the RS-BA1 software
You can download the RS-BA1 software from the Icom website[^2^]. The file name is Rsba1_up_ver194.zip and it is about 45 MB in size. You will need to agree to the terms and conditions before you can download the file.
Step 2: Extract the zip file
After downloading the file, you need to extract it to a folder on your PC. You can use any zip extraction software, such as WinZip or 7-Zip. You should see several files in the folder, such as Update.exe, Recover_Setup_Rsba1_Control.reg and Recover_Setup_Utility.reg.
Step 3: Run the Update.exe file
Double-click on the Update.exe file to start the software update. Follow the instructions displayed on the screen. The update will overwrite your previous version of the RS-BA1 software with version 2. The remote control and the remote utility software will be updated as follows:
Remote control: Version 1.94
Remote utility: Version 2.00
Step 4: Connect your Icom transceiver to your PC
Depending on your Icom transceiver model, you may need a USB cable or an Ethernet cable to connect it to your PC. Some transceivers, such as the IC-7610, IC-9700, IC-7851 and IC-7700 have a built-in network function, so you only need an Ethernet cable. Other transceivers, such as the IC-7300 and IC-7100 need a USB cable to send and receive audio signals and CI-V commands. The IC-705 can be connected to a PC over a local Wi-Fi network.
You may also need to install a USB driver or update the firmware of your transceiver before using it with the RS-BA1 software. You can find more information on the Icom website[^2^] or in your transceiver's manual.
Step 5: Launch the RS-BA1 software and enjoy remote operation
After connecting your Icom transceiver to your PC, you can launch the RS-BA1 software from your desktop or start menu. You may need to configure some settings, such as the IP address, port number, audio device and CI-V address of your transceiver. You can use the Setup Wizard in the remote utility software to help you with this process.
Once everything is set up, you can enjoy remote operation of your ham radio with the RS-BA1 software. You can switch between different modes, adjust various parameters, record voice messages, use CW keyer functions and view spectrum scope and waterfall displays. You can also use an optional RC-28 remote control USB encoder to simulate a tuning knob and two function keys.
We hope this article was helpful for you to download and install the Icom RS-BA1 IP remote control software. If you have any questions or feedback, please feel free to contact us or leave a comment below.
e033bf56a8