What if the courts-pilot bearing isn't doing its job. I'm pretty sure that in a real transmission, the pilot bearing hardly ever fails. You usually replace the pilot bearing when you drop the tranny because it's so cheap. Input shaft bearings fail (as I know) and clutch throw-out bearings wear, and you replace them with the clutch. But if the pilot Oilite bushing fails -- and I'm guessing now and going to make some assumptions -- I'm guessing it would fail because it was never replaced when it should have been. I'm guessing it would run out of lubrication, and then the heat and wear would cause the hole to grow and let the input shaft get out of alignment, and probably wander. That would cause misalignment in the gears and synchronizers and perhaps the dog clutches would be affected, too (but this is starting to get way beyond my good knowledge). So, my analogy is that the court system is so archaic -- like a pilot bushing that hasn't been changed and is still dependent on decades (or a century) old lubrication. Its ability to keep the input shaft in alignment is very poor. Its alignment-hole's diameter increases with wear, and the input-shaft alignment gets sloppy and causes misalignments and malfunctions in the transmission, generally. I think misalignment of the input shaft could cause extra wear on the input-shaft bearing, which could cause the clutch plate to get canted and then wobbly. So, Clutch-Congress and, in turn, Engine-Mr. Peebles start feeling the pain, over time, of the bad courts-pilot bearing. In other words, over a long time, defective courts cause problems for everything and everyone. Mr. Floyd and Mr. Daniel Shaver were two people whose problems were very big problems caused by defective courts.