D-link Powerline Av Utility Software Download BEST

D-Link Powerline AV Utility is a utility that enables you to configure the DHP-306AV PowerLine AV Network Adapter. The application automatically detects the device connected to your computer and it provides information such as location, signal quality, link rate and MAC address, allowing you to update the firmware.

I recently bought a new PC which I use for gaming (mostly online games like TF2). In order to play the games without lag, the sales assistant suggested I use an Ethernet connection rather than wireless. Since my computer is upstairs while my router is downstairs, I bought TP-Link powerline adapters that go through the house mains. I can't remember the model name but this is what they look like:

D-link Powerline Av Utility Software Download

DOWNLOAD 🔥 https://tlniurl.com/2y3C5f 🔥

I had similar problems, but another cause. I use the TP-link powerline adapter to connect two german routers (called FritzBox). Some FritzBox types (like 7170, and I guess, also other switches), have problems with Auto MDI-X which means he is not able to negotiate or keep up a speed and duplex mode. If you are able to set the speed/duplex mode of the switch port/network interface manually, try that first. On a FritzBox you can use a tool called cpmaccfg for that.

If your extended Wi-Fi network name is different from the main router (e.g. MyHome on the router,

TP-LINK _XXXXXX on the powerline extender), please connect to the extended Wi-Fi (e.g. TP-LINK _XXXXXX) and try again.

In case both Wi-Fi network names are the same (e.g. MyHome on the router and MyHome on the powerline extender too), you may access the management page by using the utility. Please go to the www.tp-link.com/support page and download the utility appropriate for your computer. Start the utility and choose the model to be congured and click "Connect".

Here are the IxChariot plots for the downlink powerline tests. This measures throughput between two computers plugged into the 10/100 Ethernet ports on the TL-PA4010 AV500 adapter and TL-WPA4220 AP.

Uplink results are shown in the composite plot below. This time the 57 Mbps, loce_wireless_repeat repeated throughput is actually slightly higher than best case loca_wireless throughput and much closer to the 62 Mbps measured bandwidth of the powerline connection. With direct wireless throughput of about 3 Mbps, this is an almost 20X throughput gain through the extended wireless connection.

Before joining Wirecutter in 2018, Joel Santo Domingo tested and wrote about PCs, networking, and personal tech for PCMag.com, Lifewire, HotHardware, and PC Magazine for more than 17 years. Prior to that, Joel was an IT tech and system administrator for small, medium-size, and large companies. Wirecutter has tested powerline networking kits since 2014.

The router and web server were located in a home office in the attic of the home. One powerline adapter was also plugged into a nearby outlet, with its Ethernet cable connected to a port on the router. Powerline adapters are paired automatically when you plug them in, but to ensure we had a secure connection, we tapped the pairing/encryption button on both units after they were plugged in. Note: Tor the MoCA testing during early 2021, the adapters were placed in similar test locations as the powerline adapters, connected to a working coaxial cable outlet.

For the kit that offered Wi-Fi connections on the remote adapter; we tested it using the same Dell laptop with a TP-Link T4U USB WI-Fi adapter, also about 3 feet from where the powerline adapter was plugged in.

We used an Intel NUC mini PC running Linux and Apache as the back-end server for our tests. The NUC was plugged directly into a spare port on the Archer A7 in the home office, and the test laptops had to connect to it by way of the powerline adapters.

A top powerline adapter like the TL-PA9020P improves speed (throughput) and responsiveness (latency) compared with Wi-Fi. For example, the adapter was faster than all the others in one of our six tests. At a closer distance of about 25 feet, throughput jumped from 78 Mbps on Wi-Fi to 238 Mbps, an improvement of 205%. When we increased the distance, the gap narrowed and the TL-PA9020P placed third behind the Zyxel PLA6456 and Netgear PLP2000, but the TP-Link adapter was still 76% faster than Wi-Fi at the same location.

If you need to wire more than two devices to your network over a powerline adapter, you can also connect an inexpensive network switch to the PA9020P and have enough ports to hook up your entire entertainment center. Taking those (often bandwidth-hungry) devices off your network can be a double win. Your streaming box, smart TV, the desktop hooked up to your TV, and any other local devices will benefit from the stronger signal from a wired connection, and the rest of your wireless devices will be more responsive since they are on a now less-congested wireless network.

When we tested the Trendnet TMO-311C2K and compared the results to our powerline picks, the MoCA adapters were twice as fast in the attic, and over four times as fast over 50-60 foot distances to the bedroom test location. That translates into potentially faster response and a smoother picture from streaming services to your media streaming box with a built-in Ethernet connector.

Wired connections, like those of our seven powerline adapter kits, improve the stability and responsiveness of the network connection. So we concentrated on how fast each kit was able to transfer data. Overall, the best powerline kits were faster than Wi-Fi, especially as more obstacles were placed in between the router and the test laptop.

As mentioned earlier, we tested throughput at two locations in our test home. The first site was in the attic about 25 feet from the router, but on the other side of a load-bearing wall and plate-glass window that decreased Wi-Fi signals. In general, the powerline transfer speed in an attic was quite fast, easily exceeding Wi-Fi over the same distance.

With the ability to push data into the far corners of large homes, the TP-Link TL-PA9020P powerline extender may not be the fastest kit around, but it can fill all but the largest homes with data while providing a replacement outlet and pair of Ethernet ports. On the downside, it uses more electricity than the others and its LEDs are hard to see.

Still, if you live in a large, poorly connected house, the $90 TP-Link TL-PAS9020P can put even the farthest rooms online. That alone makes it one of the best powerline extenders you can buy. (Still confused? Check out our article Wi-Fi extenders vs powerline adapters: Everything you need to know to learn more.)

In addition to Quality of Service software that allows for prioritizing Web surfing, gaming, video or Voice over IP (VOIP) selections, the TL-PA9020P comes with a useful utility. It not only shows the current connections with an optimistic appraisal of the throughput but you can remotely set up its encryption, rename each device and even turn off its LED lights.

The TP-Link TL-PA9020P is the powerline extender to get for those who live life large in a big unconnected house. It may be bigger than the D-Link DHP-601AV and slower than the Netgear PLP2000, but only the TP-Link TL-PA 9020P has the range to fill a huge home with powerline data. At $90, it is not the cheapest powerline set you can get, and will likely add to your power bill, but it pays huge dividends when it comes to connecting faraway parts of your house.

I've talked with the guy before in DMs. The powerline feature does seem to work with the out of the box defaults, just configuring it is not possible because there is no known utility that can configure the Broadcom PLC chip.

He gave up on porting the device because he could not get the same level of performance as stock.

Screenshot_20230115_124010698189 24.1 KB

The only change is in 02_network to define the extra interfaces that the M4R doesn't have. It would be trivial to create a dtsi for the 2 and create a PR for the P9.

There is also a debug firmware in case the exploit doesn't work (if the website doesn't start the download, you can do it with wget or curl):

-link.com/beta/2021/202101/20210118/Deco_P9_1.1.3_20210115_debug.zip

The TP-Link AV1200 Powerline Starter Kit (TL-PA8030P Kit) makes it easy to bring wired Ethernet connectivity to any area of your home without running cabling. This $99.99 kit uses your existing electrical wiring to send and receive data, and it's a snap to install. The two adapters in the kit contain a passthrough outlet and are the first powerline adapters we've tested that are equipped with three Ethernet ports. They're also the largest adapters we've seen. Throughput and file-transfer performance is solid, but not quite as fast as our Editors' Choice, the D-Link Powerline AV2 2000 Gigabit Starter Kit (DHP-701AV) ($125.79 at Amazon) .

Design and Features

The TL-PA8030P Kit comes with the two aforementioned powerline adapters, two Ethernet cables, and a Quick Start Guide. Measuring 5.2 by 2.8 by 1.7 inches (HWD), the three-pronged adapters are significantly bigger than the ones that come with the D-Link DHP-701AV and the Comtrend G.hn PG-9172 Powerline Adapter Kit ($59.99 at Amazon) , neither of which block the second receptacle of a two-receptacle outlet. Although the TL-PA8030P adapters restrict access to the second outlet (the ground opening is partially covered) they do have a three-pronged pass-through outlet. They also have three Gigabit Ethernet ports that you can use to connect multiple devices, such as HDTVs, gaming consoles, and media-streaming devices. Below the pass-through outlet are LED status indicators for Power, Ethernet connectivity, and powerline connectivity, and there's a Pair button on the right edge that can be used to create or join a secure powerline network, leave a network, or reset the adapter.

Installation and Performance

As with all powerline devices, the TP-PA8030P adapters are plug-and-play and a snap to install. Simply plug one adapter into a wall outlet within close proximity to your router and connect it to the router using one of the included Ethernet cables. Then, plug the second adapter into an outlet in the room where you want wired Ethernet service, and you're ready to go. To create a secure powerline network , press and hold the Pair button on one adapter for one second, then do the same on the next adapter (within two minutes). You can add up to 254 nodes (adapters) on a single TP-PA8030P network. 2351a5e196