Introduction
Nextorch sent this torch to me in exchange for an honest review. They were quite clear that they wanted honest feedback and a positive review was not a requirement.
Nextorch is not a brand that comes up often on the fora or Reddit, looking at their website they sell a range of batons and training aids in addition to torches so it appears that a large part of their market is law enforcement.
Pricing and availability
You can order from Nextorch's website here at the time of writing (18/11/2026) it is on offer for Black Friday at $87.99. Normal price is $109.99
What comes in the box?
The box is the usual nice retail box that Nextorch uses, which has useful information printed on it. Inside we find:
Headlamp with attached band
3400 mAh 18650 battery (inside the light)
40 cm USB-A to type C cable
An adaptor to allow the use of 2 x CR123 batteries
A pouch to keep it in
Printed instruction manual
Glow in the dark stickers. There are two small indented places on the top of the light where these will go, I like that these are optional, and that they give you plenty of spares.
Design and build quality
As I have come to expect from Nextorch, fit and finish is excellent. I'm going to give a special mention here to the selector ring around the LED array, this feels *excellent* in use, the action is firm but very smooth with what feel and sound like ball detents. It clicks quietly but positively into each position and feels way more satisfying than it should.
There is a lot going on at the front, a large spot LED, two smaller ones for flood at the lower centre, flanked on either side by the two red ones. These each have a TIR optic covered by a glass lens. The layout of the LEDs looks to me like a cat's paw print. :)
The head-band is 36 mm thick and has a reflective strip all the way around and a couple of silicone stripes on the inside to help it not slip on your forehead. Bands for headlamps are very much a personal preference thing, but I would have liked a top-strap. The light is snapped very securely into the bracket and tilts on a ratchet so you can adjust the position and it will stay put. I did manage to remove the light from the bracket and get it back in again, but it is held very firmly indeed and I would avoid removing it again. It is certainly not going to come off when you don't want it to.
Also present is Nextorch's UTB technology, or Ultra Thermal Buffer. This uses a phase-change material for additional cooling, it's a solid that liquifies when it gets hot allowing it to absorb more heat. As it cools down it solidifies again. Interesting stuff. Also aiding cooling are fins on the back of the head of the light.
The light has a 1 metre drop-rating, and is IP 67 water-resistant stated at 1 metre depth for 30 minutes. It also has a ten-year warranty.
Size and comparisons
Weight 151 g including battery
Bezel diameter 40 mm
Battery tube 82 mm x 26 mm
Here it is next to my headlamp of choice.
Batteries and charging
Nextorch include a protected button-top 18650 with a USB-C port. There is also an adaptor included to allow the use of 2 x CR123 batteries. The included battery arrived at 3.6 v which is ideal for preserving the battery's health in storage. It charged via USB at 5v 1.6 A, with a little red light at the top of the battery turning blue to let me know when it was complete.
Notice how proud the button is sitting. This is important because the light has a beefy plastic surround around the positive terminal for reverse polarity protection. I tried two other protected button tops from other manufacturers and the buttons were not tall enough to make contact. I measured the height of the button at 0.8 mm so this is something to keep in mind if you need to replace the battery. Given that button height is not something most battery manufacturers specify, your mileage may vary. A Fenix battery I had worked though.
I did also try using a PCB spacer with the batteries that the light didn't like and they worked, as did an unprotected flat-top with a spacer. Given that this light is dual-fuel with CR123s I'm going to assume that low voltage protection is coming from the battery rather than the driver, otherwise it wouldn't work with partially-depleted primary batteries, so would not recommend going down the unprotected route.
Battery level indication is done in my favourite way with four LEDs, each one representing 25 %. I love this system, it's intuitive and easy to read at a glance. These light up briefly whenever the selector ring is moved into a different position.
UI and switches
The UI is brilliant. The selector ring I talked about above has six positions, looking at it from the front, the order is Spot and flood < Spot < Flood < Off > Red > Red SOS. The left-hand end of the battery tube has a rotary control for smooth control of the brightness. Both controls are easy to operate when wearing the headlamp. The light blinks at the top and bottom of the brightness ramp to let you know you're at the end.
Levels and run-times are hard to quantify because of the infinitely-variable output. They're stated as below:
Spot and flood 2300 - 20 lm, 2 hours 15 minutes - 95 hours
Spot 1100 - 10 lm, 4 hours to 180 hours
Flood 1100 - 10 lm, 4 hours to 180 hours
Red 55 - 3 lm, 10 - 220 hours
LED and beamshots
The type of the LEDs is not specified, all shots below are at the highest setting. The white LEDs are cool white and low CRI.
Red looks to be in the 620 nm range.
It's hard to photograph red light outdoors using a phone!
The flood is just beautiful, it's a competely smooth wall of light. (White wall at 2 metres)
Outdoors the field of view is fantastic.
The spot beam is a bit ringy.
But outdoors it's not a problem in use. You can see the rings if you look for them though.
Spot and flood integrate nicely.
Outdoors spot and flood combine to give you the best of both worlds. The bridge between the far trees is lit up nicely from 90 metres away.
Conclusion
I actually wore the headlamp while I was out walking around and doing the beamshots for my other reviews. This is personal preference, but I would have found it more comfortable with a top strap, It did stay exactly where I positioned it though. I also know that some people hate top straps, so this could be a blessing for some. The controls are extremely easy to use, I could change modes and brightness easily while wearing the headlamp and never really needed to think about what I was doing. While I like the operation of the smooth brightness ramping I prefer to have set levels, then I know that with a full battery I have a known run-time prediction. That said, smooth vs stepped ramping is a popular holy war on r/flashlight, so pick your poison.
Thermal performance was not something I really noticed, the light stayed cool during the beamshot photos, but when I'm walking at night with a headlamp I prefer to use low levels. I don't need to see across the fields, I just need to see enough to walk safely, low level light also having the effect of not completely ruining my night vision. I really enjoyed having the red light option for that reason, and I used red the most.
The HiStar is a high-quality headlamp which offers a lot and does everything very well. It may be a bit finicky with batteries though unless you buy your spares from Nextorch.
Thank you to Nextorch for sending me the light to review. :)