How We Research
We compare products from their published specs and features; the verdicts below are our independent editorial opinions.
Updated: 2026-09-29 · 6 min read · Independent comparison
• BASN Bsinger Pro — biggest strength: Dual dynamic drivers with a 20Hz–20,000Hz range and a stated 38 dB of noise blocking, plus two detachable MMCX cables and a deep accessory set built for stage and studio work.
• BASN Bsinger Pro — biggest trade-off: It terminates in a standard 3.5 mm jack, so modern iPhones with a Lightning port need an adapter, and there is no inline mic or remote control.
• Audiovance Vibes 202ML — biggest strength: A Lightning (LTN) plug that works directly with iPhone 5 through 14, iPads and iPods, with an inline remote and mic for calls and playback, and a wide 8Hz–23kHz frequency range from a 1-Tesla driver.
• Audiovance Vibes 202ML — biggest trade-off: The Lightning connector locks it to that ecosystem — it is not for iPhone 17/16/15 — and it does not publish a specific noise-reduction decibel figure.
• Who each pick is for: BASN Bsinger Pro for musicians, drummers, bassists and anyone who wants maximum passive isolation from a 3.5 mm source. Audiovance Vibes 202ML for iPhone users who want plug-and-play HiFi with a mic and remote.
The Bsinger Pro is a wired in-ear monitor built around passive isolation rather than electronics. BASN states it blocks out 38 dB of noise, and it hands you six pairs of silicone ear tips across single-layer and double-layer styles so you can dial in a deep, sealing fit. In my opinion that combination is the whole point of this model: the more tips you can try, the more likely you land on a seal that actually shuts the outside world down.
Who should buy it: drummers, bassists, guitarists, singers and church or studio players who want a secure over-ear fit, a replaceable cable, and serious passive isolation without batteries. The MMCX connector rotates 360 degrees and there are two detachable cables, so a failed cable is a swap, not a replacement purchase. The kit is genuinely complete — a portable case, a T-shirt clip, a cleaning brush, a 6.3 mm adapter, and a 12-month warranty.
Who should skip it: iPhone-only listeners who want no dongle, and anyone who needs an inline mic and volume buttons on the cable. This is a 3.5 mm wired monitor, full stop.
Audiovance Vibes 202ML: Who It's For
The Vibes 202ML takes the opposite approach. Its headline convenience is the Lightning (LTN) plug — it works with iPhone 14/13/12/11/X/8/7/6/5, plus iPads and iPods with a Lightning port, and Audiovance explicitly notes it is not for iPhone 17/16/15. If your phone still has that connector, you get HiFi audio with no adapter and no batteries.
Isolation here is also passive, achieved through fit rather than a decibel claim. Audiovance leans on ergonomics: preformed over-ear earhooks, an in-ear nozzle shaped for the canal, and six pairs of soft eartips in two colors and three sizes. The brand's own guidance is telling — try each tip size and insert snugly to get a proper seal. That is honest advice, because with any passive in-ear, the seal is the isolation.
The driver story is a 1-Tesla dynamic driver with master-tuned chambers and an 8Hz–23kHz range, fed by a silver-plated, Litz-braided cable with 24K gold-plated plugs. Impedance is 16 ohm. The shell mixes metal, PC, resin and silicone, and the whole thing is light at 25.54 g. You also get an inline remote and mic for calls, playback and volume — the practical feature BASN leaves off.
Who should buy it: iPhone users who want wired, plug-and-play HiFi for commuting, flights and calls, and who value a mic and remote over a customizable cable system. Who should skip it: anyone on a newer iPhone, and stage players who want a swappable cable and a published isolation figure.
• Best passive noise blocking → BASN Bsinger Pro. It is the only one of the two that publishes a number: 38 dB of blocked noise, with double-layer tips to help seal.
• Best for iPhone plug-and-play → Audiovance Vibes 202ML. Lightning connector, no adapter, no batteries.
• Best for calls and quick volume changes → Audiovance Vibes 202ML. Inline remote and mic on the cable.
• Best for cable longevity and upgrades → BASN Bsinger Pro. Two detachable MMCX cables with 360-degree rotation.
• Best for low-end extension on paper → Audiovance Vibes 202ML. Its stated range reaches down to 8Hz versus 20Hz on the BASN.
• Best for easy drive from weak sources → Audiovance Vibes 202ML. 16 ohm and a 1-Tesla driver are designed for phones and small players; the BASN's 103 dB sensitivity also plays loud easily, so both are undemanding.
• Best for stage and studio use → BASN Bsinger Pro. Over-ear memory wire, a 6.3 mm adapter, a T-shirt clip, and a cleaning brush point straight at live work.
• Best accessory set → BASN Bsinger Pro. Case, two cables, six tip pairs, clip, brush, adapter and a 12-month warranty.
If noise isolation is your priority, I would buy the BASN Bsinger Pro. It is the only one of the two that commits to a figure — 38 dB — and it gives you double-layer tips plus two detachable cables to maintain that seal over time. In my opinion it is the safer pick for loud stages, drum risers and noisy practice rooms.
I would only switch to the Audiovance Vibes 202ML if you are on an iPhone 5 through 14 and want zero adapters, a mic, and a remote. It is a convenience-first HiFi in-ear, and its isolation depends entirely on how well you fit those six tip pairs. Check the current price on Amazon before you decide — value matters here, and both are wired, so neither needs charging.
how to noise cancelling earbuds
Neither of these is active noise cancelling — both use passive sound isolation, meaning they physically block noise with a sealed fit. The BASN Bsinger Pro states 38 dB of blocking with single- and double-layer tips; the Audiovance Vibes 202ML relies on six tip pairs and a snug in-canal seal.
how to noise cancelling earbuds work
Passive isolation works by sealing the ear canal so outside sound has a harder path in. The BASN uses double-layer silicone sleeves for that job; the Audiovance uses ergonomic nozzles, over-ear hooks and three tip sizes. A correct seal does most of the work on both.
how to use noise cancelling earbuds
Pick the tip size that seals without pressure, then insert and twist slightly so the bud sits deep and stable. On the BASN, the memory wire hooks over your ear; on the Vibes 202ML, the preformed hooks do the same. Neither has a power switch — isolation is mechanical.
how to noise cancelling earbuds apple
For an iPhone, the Vibes 202ML is the direct match: it has a Lightning plug and supports iPhone 14 down to iPhone 5, so no adapter is needed. The BASN Bsinger Pro is a 3.5 mm in-ear, so on a Lightning iPhone you would need an adapter to use it.
As an Amazon Associate I earn from qualifying purchases.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon and affiliated sites.
When you buy through links on this page, we may earn a commission from qualifying purchases at no extra cost to you.
Amazon and the Amazon logo are trademarks of Amazon or its affiliates. This site is an independent third-party review and is not affiliated with, endorsed by, or sponsored by Amazon or the product brands mentioned.
See also: Piluyaa KZ Castor vs L LTGEM Replacement Ear Cushions, Xmenha Ows Hanging Earphones vs GGSTOPWATER Open Ear Headphones, GREKING USB C Headphones vs Tyxmere 5.0: Wireless Stereo, Wentronic Y05 vs WUYUEGE Open Ear Clip