Thermal barriers must delay cell-to-cell thermal-runaway propagation without trapping excessive heat during normal operation. We compare conductive, insulating, and phase-change interlayers and co-design them with module cooling, temperature uniformity, and fast-charge requirements.
Related papers
Inter-cell thermal barrier materials for battery modules: Safety–thermal-management trade-offs across conductive, insulating, and phase-change layers
2026 · eTransportation, 100628
DOI: 10.1016/j.etran.2026.100628
Battery heating strategy to enhance fast-charge performance at low temperatures
2025 · Applied Thermal Engineering
DOI: 10.1016/j.applthermaleng.2025.126155
Heat-to-vehicle for fast charging of electric vehicles in cold climates
Under review
The cabin, battery, motor, and power electronics exchange heat through a shared heat-pump system. Dynamic models and predictive operating strategies coordinate these thermal demands across driving and weather conditions to reduce auxiliary energy consumption and extend driving range.
Related papers
Refrigerant charge sensitivity in EV heat pump systems: Impact of storage location and control mode in cooling and heating operation
2026 · Applied Thermal Engineering, 131065
DOI: 10.1016/j.applthermaleng.2026.131065
Proactive EV Thermal-Management Strategy for Energy Saving and Driving-Range Enhancement
2026 · SSRN · Under review
DOI: 10.2139/ssrn.7592576
Energy-Efficient Electric Vehicle HVAC System Using Waste-Heat-Regenerated Desiccant Rotor
2026 · SSRN · Under review
DOI: 10.2139/ssrn.6448670
Two-phase stack cooling system coupled with air conditioning system in fuel cell electric vehicles
2024 · Applied Energy
DOI: 10.1016/j.apenergy.2024.123811
Stack cooling system coupled with secondary heat pump in fuel cell electric vehicles
2023 · Energy Conversion and Management
DOI: 10.1016/j.enconman.2023.116961
Predictive optimization method for the waste heat recovery strategy in an electric vehicle heat pump system
2023 · Applied Energy 333, 120572
DOI: 10.1016/j.apenergy.2022.120572
Battery thermal management strategy utilizing a secondary heat pump in electric vehicle under cold-start conditions
2023 · Energy
DOI: 10.1016/j.energy.2023.126827
Optimization of injection-port design for multi-level waste heat recovery in an electric vehicle heat pump system
2023 · Applied Thermal Engineering
DOI: 10.1016/j.applthermaleng.2022.119970
Motor cooling method using flow boiling of two-phase refrigerant and its analysis with lumped parameter thermal model
2023 · International Journal of Thermal Sciences 192, 108458
DOI: 10.1016/j.ijthermalsci.2023.108458
Experimental study on an electric vehicle heat pump system with multi-level waste heat recovery using a vapor injection technique at low ambient temperatures
2022 · Energy Conversion and Management
DOI: 10.1016/j.enconman.2022.115935
Investigation on the performance enhancement of electric vehicle thermal management system utilizing floating loop with finite heat exchanger size
2022 · Energy Conversion and Management
DOI: 10.1016/j.enconman.2022.115265
Investigation on the performance enhancement of electric vehicle heat pump system with air-to-air regenerative heat exchanger in cold condition
2022 · Sustainable energy technologies and assessments 50, 101791
DOI: 10.1016/j.seta.2021.101791
Real-Time Supervisory Control Based on Physics-Model-Trained Neural Surrogates for an Electric-Vehicle HVAC System with a Waste-Heat-Regenerated Desiccant Rotor
Under review
A polymer desiccant rotor uses low-grade condenser and electric-drive waste heat to remove cabin moisture. Coupled heat-and-mass-transfer models guide rotor regeneration, air routing, and supervisory control, reducing compressor work and the need for reheating.
Related papers
Energy-Efficient Electric Vehicle HVAC System Using Waste-Heat-Regenerated Desiccant Rotor
2026 · SSRN · Under review
DOI: 10.2139/ssrn.6448670
Real-Time Supervisory Control Based on Physics-Model-Trained Neural Surrogates for an Electric-Vehicle HVAC System with a Waste-Heat-Regenerated Desiccant Rotor
Under review
Transient internal heat and mass transfer behavior of a polymer desiccant wheel for performance optimization
Under review
External heat and motor waste heat can prepare batteries for efficient operation in cold climates. We study where and when to deliver heat, how to coordinate charging with thermal conditioning, and how vehicle-level benefits change with the driving mission.
Related papers
Proactive EV Thermal-Management Strategy for Energy Saving and Driving-Range Enhancement
2026 · SSRN · Under review
DOI: 10.2139/ssrn.7592576
Battery heating strategy to enhance fast-charge performance at low temperatures
2025 · Applied Thermal Engineering
DOI: 10.1016/j.applthermaleng.2025.126155
Predictive optimization method for the waste heat recovery strategy in an electric vehicle heat pump system
2023 · Applied Energy 333, 120572
DOI: 10.1016/j.apenergy.2022.120572
Battery thermal management strategy utilizing a secondary heat pump in electric vehicle under cold-start conditions
2023 · Energy
DOI: 10.1016/j.energy.2023.126827
Experimental study on an electric vehicle heat pump system with multi-level waste heat recovery using a vapor injection technique at low ambient temperatures
2022 · Energy Conversion and Management
DOI: 10.1016/j.enconman.2022.115935
Heat-to-vehicle for fast charging of electric vehicles in cold climates
Under review