Agency 6 4Runner Molle Panel Install
Step 1
Remove interior panel. Flip panel over and remove clip from clip retainer.
Step 2
Use a 1/4" bit to drill a hole through the clip retainer and panel.
Step 3
Swap to a 1/2" bit to drill a wider hole on the opposite end using the 1/4" hole as a guide.
Step 4
Reach into the gap on the liftgate and screw the left spacer and washer into the supplied nut.
Step 5
Screw in the right spacer into the existing pull-strap location.
Step 6
Tighten the spacers with a 12mm socket. The next 2 spacers will be installed in a later step.
Step 7
Re-install the panel and guide the spacers through the drilled holes.
Step 8
Attach the molle panel to the installed spacers with the provided hardware, using your preferred tool, mark the 2 points. Note: make sure you make the mark perpendicular to the tab.
Step 9
Make the 2 marks and remove the liftgate panel.
Step 10
Drill out the 2 marks you made. You should now have 4 mounting holes.
Step 10
Install the 2 spacers to fit into the holes you just drilled on the panel.
Step 11
Tighten the spacers.
Step 12
Align the 4 spacers with the holes drilled into your liftgate panel and install the panel. Make sure your spacers are tight.
Step 13
Align the molle panel and screw in the M6-1 screws into the spacers attaching the molle panel.
Step 14
Install all 4 screws into the spacers.
Step 15
Double Check fitment.
Step 16
Tighten the screws with a 4mm allen key.
Step 17
Rock n' Roll