Some of us use our biscuit joiner daily, others on a weekly or monthly basis, but , no matter your frequency of use, eventually, you will need to replace its blade. A sharp blade keeps your joiner fast, successful and precise and when one's power tools have these qualities, usually the crafter behind it does too. Fortunately for us crafters, then, replacing the cutting tool on the Porter Cable cookie joiner is a relatively simple process. Despite a slightly more complicated computer chip deflector and lock flag, changing your Porter Cable biscuit joiner blade requires bit more than a few minutes, a screwdriver and an Allen wrench.
As with all power tool repair procedures, the first step in changing your joiner blade is disengaging and unplugging the tool. Next, simply flip the tool over and loosen the screws in the bottom plate. Your Assurer Cable biscuit joiner should have four screws and because this tool also features tapered screw holes, you will not need to completely remove the anchoring screws to remove the dish; instead you can just slide the plate off (slide the plate towards the rear end of the tool and lift to remove). This particular, naturally , gives you accessibility to the blade.
Wait! Before grabbing at the blade, though, 9 reviews you must depress the lock pin. The lock pin on Porter Cable biscuit joiners is at the most notable front of the tool (more-or-less) beneath the handle. Demanding this pin prevents the blade from spinning allowing users to safely remove it. The secret, though, is that the lock flag must be depressed constantly as you remove the blade and that the blade must be removed with an Allen wrench. So, while depressing the locking pin with your secondary hand, use your main hand to insert your Allen wrench to the center of the blade sl?, loosen and take it off. Thoroughly remove the blade.
Directly beneath the blade, the Porter Cable biscuit joiner has an adjustable chip deflector. This mechanism allows the tool to accommodate both standard sized blades and smaller face-frame blades. Depending after the dimensions of the new blade you've put onto the joiner, you may now need to modify the chip deflector. For standard sized blades, this swiveling mechanism should stay in the horizontal (left - right) position (or, more-or-less parallel to the directional arrow stamped above it). If, however, you installed a smaller cutting tool, you will need to pull the engine toward release it and shift the computer chip deflector to a up and down position (so that it now points to the front of the tool and crisscrosses with that directional arrow).
Next, you must install the new joiner blade. The blade will have a similar directional arrow printed on the surface. This antelope is designed to ensure users install the blade having its teeth facing the right direction. Install the blade so that the arrow points in the same direction as the directional arrow on the tool. Pop the blade into place and and replace the washer and bolt. While depressing the lock pin tighten the bolt over the blade.
After securing the knife, you need only slide underneath plate back into place and tighten down the four screws that keep it there. That is certainly exactly that. Give yourself a pat on the back again and know that your Porter Cable biscuit joiner is now of the same quality to go as you are.
Joining M&M Tool and Machinery and ToolsandMachinery. com in December of 06\, Mallory has refined the woman expertise in power tool elements, tool repair and many other aspects of the woodworking and production industries. Her hands-on experience with woodworking machines, power tools and strength tool parts ensure her knowledge is current, and her solid relationships with major factory representatives and M&M's own staff of experienced crafters and techs ensure her wit and info remain sharp. - Offering the most thorough inventory of power tools, replacement parts, machinery and accessories, ToolsandMachinery. com is the ultimate resource for your woodworking, crafting, DIY, and construction needs.