CBM- Coal-Bed Methane Gas?


To return to home page of this website, go to  WATER WATCH ALLIANCE HOME PAGE


 Figure 1. Map of major gas producing basins in southern Colorado. 

    In their July, 2007 press release, Lexam states that their 3-D seismic survey confirms the presence of Cretaceous-age source and reservoir rocks for hydrocarbons (natural gas) over the entire 16,000 acre area they surveyed.  They report that total prospect area is 2,180 acres in size and the two priority targets are estimated to be located 14,000 feet below the surface.  They further state that the Cretaceous-aged Dakota Sandstone is the primary target (Figure 2)

Figure 2.  Lexam's cross-section of valley sediments based on 3-D seismic data.  The buff-colored unit near the base of the section is designated as Dakota Sandstone (reservoir rock) and the green-colored rock above it is shown as Mancos Shale (source rock).  Upper Cretaceous coalbed formations overlying the Mancos Shale are not designated in the Figure.  Proposed drill locations in pristine wetlands are at the top of the section.

     Lexam consulting geologist, Thomas A. Watkins, also identified Cretaceous-aged Mancos Shale and Jurassic Morrison Formation.  Both Lexam's recent press release and the earlier geological report suggest that Lexam’s target is "conventional natural gas".  However, the nearby Raton Basin (60 miles to the southeast), San Juan Basin (100 miles to the southwest), and Piceance Basin (about 100 miles to the northwest) are currently producing extensive amounts of coalbed methane (CBM) gas from Upper Cretaceous-aged coalbeds that overlie the Mancos Shale and Dakota Sandstone (Figure 3).   

Figure 3. Stratigraphic column of geologic formations in the San Juan Basin, showing that coalbeds in the Menefee Formation of the Mesa Verde Group overlie the Mancos Shale. 

 Thus, we must ask the question: Is Lexam also hoping to find coalbed methane (CBM) gas in their drilling plan?


Coalbed Methane (CBM) vs. "Conventional" Gas

    Coal-bed methane (CBM) gas is gas that comes from coal deposits underground.  Natural gas is stored along with water in cracks and micropores in the coal.  To extract the gas, enormous quantities of water must first be pumped out (“produced”) from wells.  In 1998 (the last year for which statistics are available), over 597 million gallons of water were "produced" from the Las Animas County methane wells in the Raton Basin in southern Colorado.   A single well can require the "production" (removal) of as much as a million gallons of water.  "Produced" water is typically highly saline and sodic and, if discharged at the surface, normally renders nearby agricultural lands infertile (Figure 4).
 

Figure 4.  Schematic diagram of coal-bed methane gas well and coal bed in San Juan Basin.  In the San Luis Basin, the aquifer extends throughout the entire section.

    In Colorado, “conventional” oil and gas reservoir rocks include the Cretaceous-aged Dakota, Point Lookout, Cliff House, and Pictured Cliffs Sandstones.  The “source rocks” are thought to be the Lewis and Mancos marine shales, each several thousand feet thick.  Coalbeds, considered “unconventional” reservoirs, are found in the Fruitland and Menefee Formations in the San Juan Basin (Figure 3) and in the stratigraphically-equivalent Vermejo and Raton Formations in the Raton Basin.  Coalbeds act as both source and reservoir rocks for methane gas.   All of these formations are Upper Cretaceous in age and thus, overlie and are younger than the Mancos Shale and Dakota Group sandstone.

    Certainly, it is clear that very extensive CBM reserves are located in basins quite near to the San Luis Valley.  Schwochow (1997) and Nelson (1999) make the following estimates of the largest coalbed methane reserves in the contiguous U.S.


Location           CBM Reserves (Trillions of cubic feet or tcf)

Green River Basin, Utah                              134
Piceance Basin, Colorado                           99
San Juan Basin, Colorado                           90
Northern Appalachian Basin                           61
Powder River Basin, Wyoming                       39
Black Warrior Basin,                                  20-23
Western Washington Basin                            24
Illinois Basin                                               21
Raton Basin, Colorado                                10
Uinta Basin, Utah                                        10


    Thus, the San Luis Valley is surrounded by three of the largest CBM gas-producing basins in the United States (Piceance, San Juan, and Raton Basins).   NO WONDER THAT LEXAM BOASTS TO ITS POTENTIAL INVESTORS THAT THE SAN LUIS VALLEY IS "SURROUNDED BY MONSTERS!" (Figure 1, below).  

Figure 1. Location of San Luis Basin in relation to massive gas fields (INCLUDING COAL-BED METHANE GAS) in southern Colorado and northern New Mexico 

    However, there are very important geologic differences between the San Juan, Piceance, and Raton Basins, which are broad basins formed by folding and crustal compression during the Laramide Orogeny (about 80 to 50 Ma) and the San Luis Basin, which formed during much more recent crustal extension and rifting about 28 Ma (Geology of the San Luis Valley: What priceless treasures are buried here? Figure 1. San Luis Val).   Indeed, the Laramide basins are much more likely to contain extensive expanses of source and host rocks for hydrocarbons.

     The San Juan Basin is a much larger feature that includes 4 million acres (about 6700 square miles) and is about 270 miles wide.  Including production of both conventional natural gas and CBM, it is the second largest natural gas reservoir in the U.S.  Estimates indicate the gas-in-place in the coalbeds exceeds the gas in conventional reservoirs.  In the San Juan Basin, CBM is estimated to include 50 trillion standard cubic feet (Tscf) in the Fruitland Formation with another 34 Tscf in the Menefee Formation. There is an estimated 13 Tcf of CBM gas left in NW New Mexico alone.  The main producing formations are the Dakota, Mesa Verde, Pictured Cliffs Formations and the Fruitland coal.  Currently, about 65% of the total production of the San Juan Basin is CBM from the Fruitland coal.   

    Although one can understand why Lexam would want to compare the San Luis Basin with adjacent basins in order to attract investors, this is not a fair comparison, geologically speaking.  The San Juan, Raton, Piceance, and Denver Basins are all broad Laramide basins that formed by major crustal shortening (compression) and folding during the Laramide Orogeny about 65 to 50 million years ago.  In these basins, great thicknesses of Cretaceous sediments were buried more or less intact during downwarping of the earth's crust.  By contrast, the San Luis Basin is much narrower and was formed via crustal extension, block-faulting, and rifting about 28 million years ago.  Geologists believe that during Laramide times, this part of Colorado was well above sea level.  Hence, Cretaceous marine sediments were probably never deposited here in any significant thicknesses.  This a very important distinction because it means that Mesozoic source rocks for hydrocarbons are probably not present in commercial quantities in the San Luis Basin.   BUT.... if Mesozoic rocks are present here, why not Upper Cretaceous coalbeds and coal-bed methane gas too?

Why Mining Coal-Bed Methane Gas Is So Polluting?

  The ability of coalbed reservoirs to store methane depends upon reservoir pressure, composition and rank of the coal, micropore structure, molecular properties of the adsorbed gas constituents, and reservoir temperature.  CBM wells are drilled using techniques similar to those used for drilling conventional wells, but completion practices and the method of reservoir evaluation are different.  Because the methods used ("cavitation," hydraulic fracturing, and removing "production water") all can result in increased mixing of hydrocarbons with aquifer water, “the BLM has adopted COGCC order No. 112-61, which requires that the production casing of all coal-bed methane wells be cemented from producing horizon to surface by grout circulation methods.”  This is done in order to attempt to minimize or preclude the inter-zonal flow of fluids between producing horizons and aquifers within the casing annulus. 

    Again, both enhancement methods of mining CBM gas involve moving fluids or gases through target formations under high pressure.  Thus, both methods result in enlargement of the actual well and thus, increased potential for the mixing of hydrocarbons with groundwater and hence, contamination of the aquifer: 1) The “cavitation method” creates a cavity in the targeted coal seams by altering the velocity of the gas escaping from the coal reservoir.  This effectively enlarges the original well bore.  2) Hydraulic fracturing of rock is accomplished by pumping fracture-inducing fluidsfracture-sustaining material under high pressure through pipe perforations in the coal bed.  This essentially causes mini-earthquakes in the ground.   
and

    These mini-earthquakes could possibly trigger movement along the much larger  Sangre de Cristo fault system located along the eastern margin of the San Luis Valley within about 10 miles of the proposed drilling sites.  Past earthquakes in this area have been on the order of  magnitude 7.0.  Geological work here has established that the periodicity for approximately 7.0 earthquakes in this region is about 8,000 years.  Unfortunately, the last such earthquake occurred 8,000 years ago (McCalprin, 1982).  If a mini-earthquake were to trigger movement along the larger fault, there could be serious and devastating consequences. 

    Since methane is stored (adsorbed) on micropores of the coal, and storage is a function of pressure (the higher the pressure the greater the storage potential), production of coalgas requires reduction of water pressure within the coalbeds.  This pressure reduction frees methane molecules from the coal and allows upward gas migration.  Thus, pore-pressure reduction is usually accomplished through removal of "formation" water by walking beam pumps, submersible pumps, piston lift or gas lift. 

    Water/gas separators used for conventional gas production are modified to accommodate copious amounts of "produced" water and associated coal fines (small particles of coal that can pollute water).  After hydrostatic pressure is reduced, methane gas is desorbed from the coal and is free to migrate through permeable strata and fractures to an area of lower pressure, ideally into well bores that created the pressure reduction.   Since water must be withdrawn to reduce the pressure and allow gas migration, the volume of gas produced tends to build from a low initial rate to a maximum rate several years after the onset of production.  (Conventional gas production rates are reversed, with the highest rates at the onset and a steady decline over the life of the well.  When reservoir pressure drops below 150 psi, the well is no longer considered economic.  It is estimated that less than 50% of the coalbed methane in place can be economically recovered by reservoir pressure depletion strategy.  Thus, in areas like the San Juan Basin, enhanced production techniques have been used.

    Another one of the enhancement production techniques introduces nitrogen under high pressure through injector wells into individual coalbeds.  Nitrogen sorbtion displaces the methane on the coal molecules and reduces the partial pressure of the methane.  Beginning in the 1980’s, Amoco Production Company experimented with this technique and found that up to 80% of the methane could be recovered by introducing nitrogen gas into the coal.