Spare Parts


  • Jabsco 34600-Series 10.8 GPM
  • CQR 45lbs anchor with 30 feet of 5/16 G4 HT chain  chain and 220 feet of 5/8 rode
  • Alternator Balmar 60 series 100A with internal regulator. 
  • Fluxgate Raymarine
  • Rudder transducer Raymarine
  • Fuel electric pump
  • Emergency tiller
  • Handle for winches
  • Autopilot: Simrad TP32 to be used with emergency tiller (this is a self contained unit: fluxgate, actuator, computer not as powerful as the regular unit but I tested in gentle condition and does the job to keep course. A spare autopilot is essential especially when single handling the boat).
  • Lenovo T400 Laptop with WIndowsXP (this is identical to the Laptop used at the Nav Station, so in case of failure of one the hard disk can be exchanged)
  • Chainplate (this is one of the old one I replaced but they look in excellent condition, same apply for backstay and Upper shroud)
  • Backstay 54' 5/16 1x19
  • Upper shroud 34' 9/32 1x19
  • Swageless stud  9/32 and 5/16 (to be able to use the spare shroud for shorter section)
  • Spare battery: Optima Starter battery AGM 50 AH 800 CCA (I keep this battery just in case all main batteries go dead, this spare batter will be able to start the engine. I choose an AGM battery because of it low shelf discharge rate and the possibility to store it not vertically)
  • GPS chartplotter: Garmin Map 478 GPS
  • Electrical wire of different gauge
  • Electrical connectors of different type
  • Service kit Graco head
  • Service kit Jabsco bilge pump
  • 50 feet 1" ID hoze
  • Various hose clamps of different size
  • 1000W electric hot plate (in case the propane gas stove stop functioning)
  • Various screw (metal and wood) and bolts and nuts.
Comments