HOW TO APPLY VINYL DECAL

Step 1
When you receive the wall decal sticker, it might be rolled up depending on its size. If it is rolled, make sure to flatten it before application by laying it on a flat surface. Apply when it is flat.

Step 2
This is the most important step. Clean the area thoroughly with rubbing alcohol or soap and water. Do not use use Ammonia based cleaners like Windex or similar products because they will leave a residue behind that will prevent the sticker from adhering well. Painted surfaces should be allowed to dry really well prior to application; moisture will prevent the sticker from adhering well.

Step 3
Prepare the sticker for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape. 

Step 4
Peel the white paper backing off the sticker. If the sticker clings to the backing, slowly replace the paper backing and repeat Step 2 

Step 5
Slowly lower the sticker onto the surface and rub it in place firmly with a squeegee or credit card. The decals have a pressure sensitive adhesive, the harder you squeegee the better the decal will stick.

Step 6
Slowly peel the clear transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat. The sticker will take approximately 24 hours to cure.

NOTE: Paints that have a Teflon additive to resist dirt will not hold decals well. Also, vinyl will not adhere to low or zero VOC paints.
TIP: Use a pin to poke any air bubbles in the center and push the air out through the hole.