My RepRap‎ > ‎

ArduinoMegaShield

I looked for some eagle files for an arduino mega shield, but couldn't find any. Here's some I ripped from the Arduino reference design. It might give you a head start.

Renoir's MegaRap Shield

I built a shield for my own reprap electronics. It's loosely based on the generation3 electronics, and should allow a reprap to run off a single arduino Mega. It should be compatible with the standard makerbot stepper driver boards, and should plug in using the standard ribbon cables.
There is a (hopefully future-compatible) interface socket, which should match the new generation 4 boards. There are a couple of extra stepper sockets and a heater socket for output to a separate mosfet driver board. 
PDFs attached for printing your own boards. I've attached mirrored versions depending on your method (one for laser-printer method, one for photo-resist)


ċ
ArduinoMEGAReferenceShield.brd
(55k)
David Reynolds,
16 Mar 2010, 02:57
ċ
ArduinoMEGAReferenceShield.sch
(15k)
David Reynolds,
16 Mar 2010, 02:57
ċ
ArduinoMEGARenoir_RepShield_v0.4.brd
(41k)
David Reynolds,
31 May 2010, 13:38
Ċ
David Reynolds,
7 Jun 2010, 12:34
ċ
ArduinoMEGARenoir_RepShield_v0.4.sch
(99k)
David Reynolds,
31 May 2010, 13:38
Ċ
David Reynolds,
7 Jun 2010, 12:34
Ċ
David Reynolds,
7 Jun 2010, 12:34
Ċ
David Reynolds,
7 Jun 2010, 12:34
Ċ
David Reynolds,
7 Jun 2010, 12:34
Comments