Set Up


Materials needed are as follows:

1 - 20" section of 2" X 2" for stand crossbar (this is for a standard 18" IDPA pistol target width. Cut as desired for other target types.)
2 - 24" section of 2" X 2" for stand supports
2 - 4' (foot) sections of 1" x 2" furring strips for target supports

Assembly Directions:

  • Insert pre-cut 2" x 2" crossbar into the upper crossbar tubes and secure with the thumb screws.
  • Insert pre-cut 2" x 2" stand supports into the lower crossbar tubes and secure with the thumb screws.
  • Insert pre-cut 1" x 2" target supports into the vertical support tubes and secure with the thumb screws.
  • Secure cardboard target backer/target to supports with binder clips (staples can also be used)