Tips & Tricks


If you want to keep the same look & feel of a render at different image resolution (in 'Image' tab) you need to update the fractal resolution (in 'fractal' tab) accordingly.
Example : If you make previews at a 400x400 pixels image resolution and a fractal resolution of 8, and decide to make a final render at 3200x3200, then the fractal resolution must be 1.

The general rule is :
Image Resolution 400x400 > fractal resolution X*8
Image Resolution 800x800 > fractal resolution X*4
Image Resolution 1600x1600 > fractal resolution X*2
Image Resolution 3200x3200 > fractal resolution X

If you don't follow this rule, then you'll have essentially color changes and in some cases some slightly different architecture.

[Kaeltyk's note : I still have to test for non-square resolution to know if this is proportional to X or Y image size]
[Krzysztof's note: It is proportional to Y image size]

About the 'Shaders' Tab


Remember almost every parameter in this tab can be changed after (or while) rendering !
The exceptions are :
• Background colors can't be changed at all after starting a render.
• If the Colored Surface option is not checked when starting a render it can not be turned on - if it's on then it can be turned on/off after rendering.
• Shadows and Ambient Occlusion flags can't be changed (in fact they can but this is not applied).

Playing with parameters below 0 or above 1 can make some unrealistic but nice results, and especially an Ambient occlusion level above 1 does create some more colorful results. Don't be afraid to experiment as this can be reverted with the undo option anyway.

About Camera and its Yaw / Pitch / Roll parameters


The 'Viewport Coordinates' is the 3D point that the camera targets.
The Yaw / Pitch / Roll are the angles that are applied to make the camera rotate around this point. (Yaw is rotation to make the camera look left/right, Pitch is rotation to make the camera look up/down, then Roll make the result turn around the camera axis).

By default when clicking in the fractal to zoom in, the new camera point is right in front of your nose so you can rotate the camera to look around - very nice if you want to navigate 'in' your fractal.
Now if you activate the 'Go close to indicated surface' checkbox the camera point is 'on' the fractal so you can rotate the camera around the fractal.
Using both modes can be very usefull - but remember the point will only be updated when you click to zoom in/out.


NOTE!

Website under development!
Comments