1. Water Rockets‎ > ‎Rocket Blog‎ > ‎

3D printed Pikachu

posted 29 May 2017, 13:03 by Andy Lakin-Hall   [ updated 29 May 2017, 13:42 ]

Duncan found a Pikachu model on Thingiverse. I needed to make a couple of changes to the design, including mounting the model on a larger base, that also had a hollowed bottom to avoid warping. I added lettering to the edge of the base too. Duncan added a hat with a peak to top things off.

The model was smoothed, and then primed with white spray primer, before a base coat of acrylics.


I added a wash of thinned orange to darken shadowed areas, and then added some highlights and detail to finish.




Comments