LP-568E

eMMC Programmer LP-568E Introduction:

• eMMC programmer LP-568E can directly select file and set the parameter through the software edition which is able et the partition and Extended CS D setting. 

• eMMC programmer LP-568E able to read out the file from the master IC,and set as project to program. It can be operate by thesource from eMMC master or file to reach gang 8 programming.

• eMMC programmer LP-568E is not only support eMMC, but also NAND, SPI NAND, NOR and MCU. It is the best solution to improve the total production yield rate and quality.

eMMC Programmer LP-568E Features:

• eMMC edition function for engineer can select file and set the parameter to magnetic segmentation setting, Extended CSD

• seeting and so on. Afte the setting, IC can be directly program.

• Programmed IC can be read the file and set to the project format which can be copied.

• SSD module is eMMC program ming project storage device which can be replaced the capacity depend on the programming requirement. Standard accesory is 32GB, optional is 64GB.

• Support SPI and NOR FLASH IC, NAND FLASH etc mass capacity memory device program.

• Project and mass product mode can be completed by LP-568E.

• Mass prodction-oriented operation desigh: Technical staff set the work order device part number, file, process, parameter

• and set the project to download. Operator just need to boot the mechanism and choose the project, put the correct IC ,

• the LP-568E will automatically program it. Put the staff operation risk in the low key.

• Able to use the same adapters for the AH series.

• eMMC press mechanism design: press the press bar can open the all socket which can be more easily to replace the IC.

eMMC Programmer LP-568E Specification:

• Log IC signal level: 1.5V~6.0V,10mV

• IOL,IOH current: 10mA ,75MHz (3~5V)

• Embedded storage device: 2GBytes FLASH memory

• Module Size:120mm(Length) x 75mm(Width)

• Size: 400mm(Length) x 150mm(Width)x 310mm(Height)

• Weight: 8 kg

• Support device: eMMC, eMCP, NOR/NAND/SPI FLASH....etc.

• Support file format: Binary/Machine Code, Intel HEX,TEK HEX, Motorola HEX

eMMC Programmer LP-568E Requirements:

• Operating system: Windows 10 / Windows 7 / Vista /XP ( 32bits & 64bits )

• Processor: Pentium 4 above

• Memory: 2 GB RAM above

• Hard disk: Main program 500MB above, Data buffer 1 GB above (depend on device capacity)

• Communication interface: USB 2.0 HIGH SPEED

eMMC Programmer LP-568E Standard Accessories:

• Main unit: 1 unit

• USB transmission line: 1 pc

• AC power cable: 1 pc

• LP-568E convertor: 4 pc 1 set

eMMC Programmer LP-568E Optional Accessories:

• SSD module: 32GB, 64GB

• eMMC adaptor :LP-568-eMMC(BGA153x2) (11.5X13)(11X10)

• Press bar: for NAND, NOR, SPI