LP-562E

eMMC Programmer LP-562E Introduction:

• eMMC programmer LP-562E can directly select file and set the parameter through the software edition which is able et the partition and Extended CSD setting.

• Moreover, eMMC programmer LP-562E is able to read out the file from the master IC, and set as project to program. 

• eMMC programmer LP-562E can be operate by the source from eMMC master or file to reach gang 2 programming. LP-562E is not only support eMMC, but also NAND, SPI NAND, NOR and MCU. LP-562E is the best solution to improve the total production yield rate and quality.

eMMC Programmer LP-562E Features:

• eMMC programmer LP-562E provide the software which is able to edit and set the partition and Extended CSD.

• eMMC programmer LP-562E is able to read out the file from the master IC, and set as project to program.

• High-speed programming to support high-density eMMC, NAND, SPI NAMD, and NOR.

• Provide mass-production-oriented software, which is able to minimize the operator error. Moreover, the log file can help the production management.

• Provide the eMMC press bar mechanism design, which make the LP-562E operate easily.

eMMC Programmer LP-562E Specification:

• Log IC signal level:1.5V~6.0V,10mV

• IOL,IOH current:10mA, 75MHz (3~5V)

• Embedded storage device:2GBytes FLASH memory.

• Size: 400mm(L) x 150mm(W) x 310mm(H)

• Weight:2.4 kg

• Support device: eMMC, eMCP, NOR/NAND. SPI FLASH....etc

• Support file format: Binary/Machine Code, Intel HEX, TEK HEX Motorola HEX

eMMC Programmer LP-562E Requirements:

• Operating system:Windows 10 / Windows 7 / Vista /XP ( 32bits & 64bits )

• Processor:Pentium 4 above

• Memory:2 GB RAM above

• Hard disk:Main program 500MB above.Data buffer 1 GB above (depend on device capacity).

• Communication interface: USB 2.0 HIGH SPEED

eMMC Programmer LP-562E Standard Accessories:

• Main unit: 1 unit

• USB transmission line:1 pc

• AC power cable:1 pc

• LP-568E-DRIVERBOARD:1 pc