Mouldings




Leisure 17 Mainhatch


This item is supplied requiring minor trimming, to suit your particular boat.












Leisure 17 & 17SL Rudder

Photo also shows a tiller head fitting. The one shown is in cast alloy; new items are now being machined from solid alloy, but look very similar.









Leisure 20 Rudder & Skeg

The rudder shown has been antifouled. They are normally supplied in white gelcoat finish, and are ready to fit. Note that the rudder has a 'flared' leading edge.

Leisure 20 skegs can also be supplied (no photo available).











 
Leisure 22 Rudder & Skeg

This rudder was one that was used to make a pattern. New rudders are normally supplied in white gelcoat finish, and are ready to fit. Note the 'flared' leading edge and the heavily 'flared' trailing edge, quite unlike the straight edge of other Leisure yacht rudders.















The Leisure 22 skeg is different from all other Leisure skegs, in that it has a 'rounded' top section that fits into a moulded recess in the hull.

L23SL for'd hatch


This item can be produced in a variety of colours to match the main hatch -but only the green finish will b translucent



L20 fore hatch lid




Leisure 17SL and L23SL Mainhatch

These items are supplied requiring minor trimming, to suit your particular boat.




Leisure 17 Anchor Lid

This item is supplied ready to fit the boat without further trimming being required.



Note: Some Leisure 17's are fitted with the alternative design of locker lid shown below, these are not the same size !


Leisure 17 SL Anchor Lid

This item is supplied ready to fit the boat without further trimming being required.




Note: there is a minor defect in the moulding of the non slip pattern (an old lid with a small scratch was the pattern for the new mould).


Leisure 23 and Leisure 23SL Rudder and Skeg

The Leisure 23 and Leisure 23SL have identical hull mouldings, and the skeg and rudder are common to both yachts.

Both rudders (no photo available) and skegs can be supplied.



Note the straight rear edge of the skeg (the rudder has a corresponding straight leading edge, and a straight trailing edge).

They are normally supplied in white gelcoat finish, and are ready to fit.

Instrument Pod for the L27 and L29

L17 old style - cockpit  locker lid - it requires the slots to be cut in but as they vary it has to be done to suit each individual boat