Adjustable wastegate

Once the waste gate is removed measure the rod length. Once you have the length, cut out a 1/2 -1 inch section from the center of the waste gate rod. With a ¼ 20 die thread both sides of the waste gate rod. Using a pipe coupler or threaded hex join the two half’s of the waste gate together. Do not forget to add two jam nuts locking in the pipe coupler. Reinstall waste gate on the car with the same length rod as stock. To increase boost shorten the rod by turning in. to decrease boost lengthen the rod. Make sure to watch your boost gauge. Do not go crazy with boost. Only turn up boost 1 PSI at a time. Know your limit before attempting to increase boost. Too much boost could cause catastrophic losses.