Stranger 5 20Watts
Unique wooden combo amplifier, single channel, clean and drive mode, 3 band EQ, spring reverb, powered by 2 6V6 tubes in push-pull configuration, output power reduction switch, 12" Jensen C12Q vintage speaker
Unique wooden combo amplifier, single channel, clean and drive mode, 3 band EQ, spring reverb, powered by 2 6V6 tubes in push-pull configuration, output power reduction switch, 12" Jensen C12Q vintage speaker
Pure dark wooden combo with an unique finish. 12 inch speaker driven by 2 6V6s giving ~20Watt output power. 3 stages pre-amp and spring reverb gives excellent sound with full of basses, clear high and gentle mids.
September 2019
Sound samples of Stranger 5 20 Watt...
Amp no hum and noise demo
Strat neck/neck+mid pickups on clean with bit of reverb
Strat bridge+mid pickups on clean
Strat bridge+mid pickups on clean with lots of reverb
Strat neck pickups with drive on
Les paul with drive on and reverb
Les paul on clean
Specification
Cabinet style: treated darken wood with exposed wood structure
1x 1/4" input, INPUT
1x 1/4" output speaker - possibility to connect amp to external speakers with the same impedance 8 ohm
1x12" Jensen C12Q 8 Ohm speaker
Pre-amp section: 2xECC83/12AX7, 1xECC82/12AU7 or 1xECC83/12AX7
Power amp section: 2x 6V6GT
Gain and Master volume
Clean / Drive sound switch
3 band EQ: high, middle and low
Spring reverb* with foot switch (on/off)
Output power switch Half / Full for amp power reduction between 5 - 20 Watts
Point-to-point wired circuit, no PCB
Tube heaters power supply referenced to ground - no hum noise
No negative feedback
Power supply ~230-240V,50Hz, ~100W
Size: 43 cm height, 40 cm width, 23 cm depth
Weight: 13 kg
* - reverb circuit has been connected over gain control which makes wet signal much stronger compared dry when gain is less than max. By this configuration reverb effect can get really strong while still player is able to control it.
Lets take a look on Stranger 5 20 Watt...