Add a clash to an interface
This section is about linking a clash detected by Navisworks to an interface in Relatics
This section is about linking a clash detected by Navisworks to an interface in Relatics
Add clash
Add clash
You must run the "Clash Detective" tool in Navisworks before you can send clash results to Relatics.
The "Send Clash Results" tool reads the clash results which are stored in the Navisworks document.
In the iBIM Connector window, click on "Home" and select "Interfaces"
Right-click on the interface affected by a clash
Select Data and click on "Send Clash Results to Relatics" in the ribbon or in the right click menu.
Select the clash result you want to link to the interface
Validate by clicking on OK
The iBIM Connector confirms the clash has been successfully sent to Relatics
Parent topic: Advanced functionalities