Immunology

Experiment 10

Aim of the Experiment

To learn the technique of latex agglutination

Introduction

Agglutination is a reaction of clumping together of antigen-bearing cells, microorganisms or particles in the presence of specific antibodies (agglutinins) in a suspension. Reaction time for agglutination to occur is shorter compared to other antigen-antibody interactions. Latex agglutination makes use of latex particles which are built from different organic materials to a desired diameter, and may be functionalized with chemical groups to facilitate attachment of molecules. Latex agglutination tests have been in use since 1956 to detect a wide range of analytes in the clinical laboratory. The first description of a test based on latex agglutination was the ‘Rheumatoid Factor Test’ proposed by Singer and Plotz in 1956. It can be used for detection of both antigen and antibody.

Principle

In latex agglutination, antibodies are adsorbed to the latex particles (under appropriate ionic and alkaline pH conditions) by binding to the Fc region of antibodies leaving Fab region free to interact with antigen present in the applied specimen. The use of smaller latex particle has improved the sensitivity and reagent longevity of latex agglutination.

Applications of Latex Agglutination Tests:

Latex agglutination tests are very popular in clinical laboratories. These tests are applied to the detection of many infectious diseases. To detect microbial and viral infections, autoimmune diseases, hormones, drugs and serum proteins. To check for certain antibodies or antigens in a variety of bodily fluids including saliva, urine, cerebrospinal fluid, and blood.

Materials required

• Antigen Solution- Solution A

• Negative Control- Solution B

• Positive Control- Solution C

Disposable Agglutination Cards

Disposable Mixing Sticks

The Antigen solution contains inactivated antigens reactive with Test reagent and non-reactive with Control reagent.

The Negative control contains latex particles coated with non-specific antibodies

The Positive control contains latex particles coated with specific antibodies

Procedure

1. Before starting the experiment, gently mix all the bottles provided in this kit.

2. Add 1 drop of Solution A (25μL) into the circles marked as 1 and 2 of a clean dry agglutination card.

3. Add 1 drop of Solution B (25μL) into circle 1.

4. Add 1 drop of Solution C (25μL) to circle 2

5. Spread the drops over the area of both the circles using fresh mixing stick for each circle.

6. Rock the card gently (approximately two to three minutes) and observe for agglutination. An agglutination reaction is indicated by visible aggregation of the latex particles.

7. The circles marked as 3, 4 and 5, 6 can be used similarly

8. After performing the experiment, discard the slides and mixing sticks.