This October a group of us met 1st at Tinker and then at Carol's house to create Hypertufa "stuff". Click below to see what we created. Part 1 was held at Tinker and taught by Laurie Burtner Hypertufa Workshop - Saturday August 16 & 17 from 6PM to 8PM at the barns at Tinker Nature Center on Calkins Road.
Master Gardener Laurie Burtner has volunteered to do a
hypertufa workshop for our group. Members would pay only for
materials - just a few dollars. We would need to meet for about 2.5
hours and then again for about an hour the next day.
Here is a list of the items that you would need to collect
- some could be shared. We would need to purchase the product to make the mix,
so an accurate count is necessary. There are also pictures below of a planter
and a mill wheel that Laurie has made.
Your mold
1 Large flat
mixing container (approx. 30x 24x 6 deep) in shed
Face Mask - a
white painters face mask (important to use especially when mixing dry
ingredients)
Water Spray
Bottle - $1 store bottle or reused Windex or soap spray bottle is OK
Sharp old
kitchen knife, for cutting wet tufa and scraping edge of planter
Wire brush
(for when planter is unmolded)
Rubber Gloves
- thick Rubbermaid type
| 
