Welcome to bladecpupgrades.co.nr A site dedicated to helping you find the right upgrades to make your cp fly sky high. Have ever wondered what upgrades you could add to your heli to make it fly circles aroundÂ
a t-rex 450? Have you ever wondered how you would install everything into your helicopter? If you have, you are at the right place.
Welcome everyone! Whether you are only doing one small upgrade or trying to go separates with you blade, you can find all the needed information to do them right here on this site. As
you progress in your skills, you can come here and do another upgrade to make your cp fly to your liking.
This website will be upgraded periodically with new upgrades/mods/helpful tips that I have learned that will help make a bigger, better, and badder blade cp pro!! Scroll down to see the
current upgrades that are available for you cp pro!
One of the many helpful upgrades you can add to your cp pro is a full brushless system. This little piece of equipment will really help you when you need to do those very demanding inverted hovers or pulling out of close calls that you could have never done otherwise. Finally this upgrade will give you longer runtimes. If you are only doing hovering. you can fly for practically 20 minutes. (I have actually recorded myself hovering for 23 minutes.)  Another very worthy upgrade to mod your cp would be the GWS DD tail mod. This will allow you to have much more sensitive rudder imputs. You can also buy different blades with different pitches that will allow you a more or less sensitive rudder. This upgrade will mildly decrease you flight time by about a minute with the most sensitive blade pitch (3020) and increase it with the least sensitive pitch (4030).
 Learn how to repair your rotor blades with regular wood filler after a small crash so that you do not have to spend so much money on new blades. Also find out how to make your blades stronger with packaging tape so they are less likely to fail in crash. This upgrade will not increase or decrease you flight time, but it will make the helicopter maybe ten grams heavier.
 Is the center of gravity off on your cp? Are you unable to move your battery back far enough to account for the extra weight on the back of your helicopter? Mod your battery holder so that you can easily change the COG. With just a few cuts you can be able to move the battery anywhere you want!
 This upgrade will definitely help you whether you are a beginner flyer, or if you are an expert 3D flyer. The G110 or G90 gyro will be much better than the ones one the stock cp. With it, you will not have to keep re-adjusting your rudder trim as the battery depletes and you will not have the tail mess up on you when you try to do any type of 3D trick. You can also plug it in to channel 5 on your receiver so that you can remotely adjust the gain from your controller.
 This is a very pleasing mod to add to your helicopter. A 2.4 GHZ receiver will never get any interference because it has an almost unlimited number of channels that it can connect to the transmitter with. The best part of all is that you can now "program" your helicopter through your transmitter. If you have any spectrum or JR digital transmitters, the dx6i, dx7, dx7se, X9303, or the JR12x, you will be able to adjust the travel rates, expodential, dual rates and more. This will allow you to fly more to your liking.
 For this very exciting upgrade, you will finally be able to go separates on you blade cp, but you have to have almost all of the previously mentioned upgrades and a couple more things. Including a Brushless System, a gyro, a 2.4GHZ receiver, and a tail esc. When you have upgraded your heli to this setup, you will have a separate electronic configuration and a top of the line Blade cp pro (now a Blade cp pro 2) This will definitely give you much more control and options over what you want the helicopter to do.
  |