ANGLE DRILL BIT : DRILL BIT

ANGLE DRILL BIT : DRILL CHUCK FOR LATHE

Angle Drill Bit

Drill bits are cutting tools used to create cylindrical holes. Bits are held in a tool called a drill, which rotates them and provides torque and axial force to create the hole. Specialized bits are also available for non-cylindrical-shaped holes.

Mini-Cons are a human-sized race and faction of power-enhancing transforming robots in the universe and its sequels, one of the assorted universes in Transformers fiction.

drilling bit: a bit used in drilling for oil

move or proceed at an angle; "he angled his way into the room"

Seek something desired by indirectly prompting someone to offer it

Fish with rod and line

the space between two lines or planes that intersect; the inclination of one line to another; measured in degrees or radians

lean: to incline or bend from a vertical position; "She leaned over the banister"

A fridgid ghost

I have just finished taking photos up in the top and I got a lift down with these two workers. I had not taken any photos of their ingredient has been thought about it a lot because they were just screwing on the panels on the side of the shop. But as they were lifting down one of them asked if I would take photos of them so I agreed. At first I stood directly beneath them and shot up but I captured only the drill bits because the bottom of the scissor lift was obstructing the view. So I tried more angles and I arrived at this one where the sun was reflecting off the matte finish of the shop. This created a shadow and reflection at the same time. I tried really hard to isolate the workers including only the sky and the white side of the building. And then I again went into our shop and continued working.

Stairway to Heaven project

Part of the new stair railing jigged up. I drilled 7 1" holes at 37 degree angles with a 1" Forstner bit. So far, so good. I guess it looks like a big wooden flute. Not that that's a bad thing... Keen followers of this cartoon strip will note I've changed from a cordless DeWalt drill to a Craftsman 1/2" corded drill. These big holes were sucking the cordless dry too quick and I'm an impatient old fart.

3 PIECE DRILL SET

ANGLE DRILL BIT : DRILL BIT

Angle Drill Bit

Comments