Crappy photo of a crappy case. ANTEC is awesome, but even great companys make crappy products time from time. The case finger prints way too easy. The case came broken. The front door latch was broken. Antec did send out a replacement part. I've left the door off because I am afraid it will break yet again. The DVDRW would not mount in to the case as the case was a few mm too skinny. I had to push hard to get it into the top most position. Took about 45 minutes. However I realized the door wouldn't close with it in this position. If I do put the door on, I want it to close. Same thing with the bottom position. The DVDRW could only be mounted in the middle drive bay if I want the case door to close. The metal was not straight, so mounting the motherboard was a pain. Getting the wierd case porting mounted right was a long process. And the airflow in the case is from the rear and then back out the rear. So it creates a circulation keeping the case very warm. The motherboard apic often has a higher temperature than the processor does. The power supply is awesome, though. And the power supply alone costs $99 at best buy, which is what I paid for this entire case with PSU at Newegg.com. But alast, the PSU failed after less than a year. RMA was easy, but took about a week.

Antec Case - Internal Crushable Cardboard used for each end of the case - No Damage