- To turn the instrument on press either the MODE or PROGR keys.
- Using the MODE and PROGR keys select the
appropriate measurement ‘Program’. The program stored in the particular
location is listed in the display. The measurements the program
actually makes are listed in the table below. You need to check these
and select the particular program you require. A more complete
explanation of each program is listed in the manual. (section 6.3.1)
- Point the instrument appropriately and press the MEAS button the appropriate number of times for the particular measurement.
- The result will be displayed in the eye piece.
- There are 18 different measurement types available (Section 6.3.1 of the manual)
| Default
Memory
Location
| Prog
No
| Name in display
Name
| Description
|
| ModeA Progr1
| 01
| direct D
| Direct Sloping Distance to a single point
|
| ModeA Progr2
| 02
| reduc D
| Reduced Horizontal Distance to a single point
|
| 03
| track D
| Continuous distance tracking to a single point
|
| ModeA Progr3
| 04
| offset D
| Difference in horizontal distance between two points, returns horizontal distance and slope angle between the two points.
|
| ModeA Progr4
| 05
| local H
| Position Height; returns the height of a point and the horizontal distance to the point.
|
| ModeA Progr5
| 06
| plumb H
| The Perpendicular height between two points
|
| ModeB Progr1
| 07
| height H
| Height difference between two offset points
|
| ModeB Progr2
| 08
| plumb 3H
| Height difference between three points on a perpendicular.
|
| ModeB Progr3
| 09
| plumb TH
| The height difference between four perpendicular points. This
returns the height difference between the first three points then the
additional height difference to the fourth point.
|
| ModeB Progr4
| 10
| track H
| Continuous height tracing to a single point.
|
| 11
| inclin A
| Continuous angle of inclination
|
| ModeB Progr5
| 12
| Slope A
| Slope offset angle between two points returns the angle and the horizontal distance
|
| 13
| azimut
| Continuous azimuth angle
|
| ModeC Progr1
| 14
| crss dD
| The direct distance between two points. It returns the direct
distance (the hypotenuse) and the height difference between the two
points.
|
| ModeC Progr2
| 15
| crss rD
| The horizontal distance between two points. Returns the horizontals difference and the height difference
|
| ModeC Progr3
| 16
| velocity
| A single measurement of velocity
|
| ModeC Progr4
| 17
| velotrck
| Continuous velocity measurements
|
| ModeC Progr5
| 18
| D-scan
| Continuous distance measurement
|
- If the program you need is NOT in a memory location.
- Ensure the instrument is OFF
- Hold the MEMORY key
- Press the MODE key
- Press the MEMORY key until the display shows the current ‘MODE and PROGR’ together with the program installed in that location i.e. A1–01
- Press the MODE and PROGR keys to select the appropriate memory location you want to use
- Press the MEMORY + and MEMORY – to select the
program number you want to access from that location. i.e. A1 13 will
give you the ‘azimut’ program in the A1 location. The default for A1 is
‘direct D’ measurement program 01.
- Press Off then Mode again to restart the instrument
|
|
