EMD/GMDD Full Width Waste Retention Tank
Parts Layout:
Instructions:
- Bend (Tank Body) to form a box. All bends are 90°. Fold lines should be inside the structure and not seen from the outside.
- Attach (Tank Bottom).
- Attach (Tank Top) with circle half etched facing upwards.
- Attach (Inspection Plates).
- Attach (Drain Base) and detail with plastic rod.
- Mount tank to the rear of fuel tank using photographs as a guide.
- Attach 0.040” rod to top of retention tank where half etched circle exists.
- Attach (Inlet Cover) to rod in step (7).
- Bend (Tank Mounts) 90° with bolt detail facing out. Attach to assembly. Add strip styrene on fuel tank wall as depicted in photo-graphs if desired.
Prototype Photos:
Model Photos:
Buying Parts:
You can see your local dealer for this item or shop direct at:
| 
