EMD Angled Waste Retention Tank
Parts Layout:
Instructions:
- Remove the (Tank Front), (Tank Rear), and (Tank Side) from the fret. Bend the (Tank Side to follow the outline of retention tank. The two ends meet in the center at the bottom of the tank. Ensure all fold lines are hidden. The side detail should be on the outside when properly folded. Attach parts to form the tank.
- The brackets do not have to be added to the tank. Follow your prototype references.
- Attach the (Drain Base).
- Attach the (Inspection Plate).
- Attach the (Top Bracket) if desired. Bend the part so the rear edge butts against the rear edge of the tank side and the front prongs overlap the front face. These are used with a vertical plate however not every prototype has them.
- Bend the outside corner of (Bracket 1b) 90° along the fold line. Insert the (Bracket 1a) into the half etched area and bottom half etched bottom of the (Bracket 1a) over lapping to top of the retention.
- Bend the outside corner of (Bracket 2b) 90° along the fold line. Fold the (Bracket 2a) so one end is up, the middle goes horizontal and the opposite end overlaps the side of the retention tank.
- Attach to your model.
Prototype Photos:
Model Photos:
Buying Parts:
You can see your local dealer for this item or shop direct at:
| 
